Texas Instruments

The SN74HC238N is a 3-line to 8-line decoder with active-high outputs in the high-speed HC CMOS logic family. It operates from 2 V to 6 V supply and decodes 3 binary address inputs into 8 mutually exclusive output lines with enable control. Available in a 16-pin DIP package for through-hole address decoding and memory bank selection.

TUSB1210-Q1 is an automotive-qualified USB 2.0 ULPI transceiver from Texas Instruments supporting high-speed 480 Mbps and full-speed 12 Mbps operation with a ULPI interface for connection to application processors. It is packaged in a compact QFN for space-constrained automotive designs. Available from authorized distributors with worldwide shipping.

Use the download button to access the ISO6763DWR schematic symbol, PCB footprint, and 3D model.

Use the download button to access the DRV8231ADSGR schematic symbol, PCB footprint, and 3D model.

Differential Amplifiers High-precision (40-uV offset), 2-MHz, 88-dB CMRR, low-power, e-trim difference amplifier

Translation Transceiver 2 Element 8 Bit per Element 3-State Output 24-VQFN (5.5x3.5)

Precision (200µV offset), 2MHz, 88 dB CMRR, low power, e-trim™ difference amplifier

Operational Amplifiers - Op Amps 40-V, single 10-MHz, rail-to-rail input/output, low-offset-voltage, low-noise op amp 5-SOT-23 -40 to 125

TCA6408ARGTR is a Texas Instruments 8-bit I2C I/O expander with 2-wire bus interface at up to 400 kHz, providing 8 configurable GPIO pins in a compact 16-pin QFN package. Supports 2-address selection via address pin and 1.65 V to 5.5 V supply voltage range. Available from stock with worldwide shipping.

Use the download button to access the BQ25180YBGR schematic symbol, PCB footprint, and 3D model.

Texas Instruments TPS40075RHLT is a voltage-mode PWM synchronous buck controller operating from 4.5 V to 28 V input in a 20-pin QFN package. Supports adjustable output and programmable frequency up to 1 MHz for compact power supplies. Available in stock worldwide with competitive pricing.

Module DC-DC 1-OUT 0.6V to 5.5V 7A 42-Pin B3QFN T/R

TPS62A01DRLR is a high-efficiency PWM step-down switching regulator from Texas Instruments supporting 2.5 V to 5.5 V input voltage with PSM control technique available, packaged in a compact 6-lead SOT-563 flat lead for space-critical portable and IoT applications. Available from stock worldwide with competitive pricing.

Use the download button to access the LM5168FDDAR schematic symbol, PCB footprint, and 3D model.

Operational Amplifiers - Op Amps Low Pwr Dual Op Amp

TL084HIDYYR is a quad JFET-input general-purpose operational amplifier with ±20 V dual-supply or 40 V single-supply operation in a 14-pin TSOT-23 package. It provides 0.00012 µA max bias current, 100 dB minimum CMRR, and wide bandwidth for precision signal processing. In stock worldwide with fast shipping.

TLE2024CDWG4 is a quad precision operational amplifier from Texas Instruments in a 16-pin SOIC package. It features 88 dB minimum CMRR, 0.09 µA maximum bias current, and voltage-feedback architecture for low-noise signal conditioning. Available from stock worldwide with competitive pricing.

Texas Instruments

The TMS5701227CZWTQQ1 is an automotive-grade 32-bit ARM Cortex-R4F microcontroller from Texas Instruments, clocked up to 80 MHz with integrated ADC, DMA, and boundary scan support. It is AEC-Q100 qualified for functional safety applications, packaged in a 337-ball BGA for high pin-count automotive system designs. Available worldwide for powertrain, chassis, and body control modules.

TPSM63603RDHR is a current-mode PWM switching regulator power module from Texas Instruments accepting 3 V to 36 V input with a 24 V nominal, integrating the controller and power stage in a 30-pin QFN module for compact industrial and automotive DC-DC step-down conversion. Available in stock with worldwide shipping.

Communication ICs - Various TONE DECODER

• Programmable voltage or current outputs with flexible configuration: – Voltage outputs: • 1 LSB INL and DNL (10-bit) • Gains of 1x, 1.5x, 2x, 3x, and 4x – Current outputs: • 1 LSB INL and DNL (8-bit) • Unipolar and bipolar output range options from 25 μA to 250 μA • 35-μA/channel IDD in voltage-output mode • Programmable comparator mode for all channels • High-impedance output when VDD is off • High-impedance and resistive pulldown powerdown modes

Analog to Digital Converters - ADC 12B ADC with Int MUX PGA Comp Osc and Ref

TPS25970ARPWR is a single-channel eFuse power protection IC with adjustable overvoltage and overcurrent thresholds supporting 2.7 V to 23 V input range in a 10-pin WSON package. Available in stock worldwide with fast shipping.

Digital Isolator Logic 6-CH 50Mbps Automotive AEC-Q100 16-Pin SOIC T/R

The TLV9361IDBVR is a single-channel, MUX-friendly operational amplifier from Texas Instruments with a 10 MHz gain-bandwidth product, 40 V rail-to-rail output swing, and 95 dB minimum CMRR in a compact SOT-23-5 package. It tolerates multiplexer-driven input steps without phase reversal, making it ideal for multichannel acquisition systems. Available from stock worldwide.

16-bit, 860-SPS, 4-channel, delta-sigma ADC with PGA, oscillator, VREF, temp sensor and SPI

Use the download button to access the ISO6761DWR schematic symbol, PCB footprint, and 3D model.

Use the download button to access the AM6548BACDXEAF schematic symbol, PCB footprint, and 3D model.

TPS25865QRPQRQ1 is an automotive-grade dual 2.4 A USB Type-A charging port controller from Texas Instruments supporting 5.5 V to 26 V input with load shedding in a 25-pin VQFN-HR package. It meets AEC-Q100 qualification and operates from -40 degrees C to 125 degrees C for harsh environment use. Available from stock with worldwide shipping.

Battery Management Sync Switch-Mode Li-Ion Charger

Logic Gates Sngl 3 Inp Pos OR Gate

Texas Instruments TLV9022DSGR is a dual precision comparator with open-drain output in a compact 8-pin WSON package. It features a maximum input offset voltage of 1500 µV and operates over a temperature range of −40°C to +125°C. Available from stock with worldwide shipping.

The TMP114CIYMTR is an ultra-precise 16-bit digital temperature sensor from Texas Instruments with ±0.2 °C maximum accuracy. It communicates over a 2-wire I2C interface, draws only 1.5 µA during operation, and is housed in a tiny 0.758 mm × 0.758 mm BGA package for space-constrained IoT and wearable designs.

Battery Management 800-mA JEITA-compliant linear battery charger for 1-cell Li-Ion and LiFePO4

The TPS7A2133PYWDJ is a fixed 3.3 V, 500 mA positive LDO linear regulator from Texas Instruments with a 130 mV typical dropout voltage and 3.6 V to 6 V input range, housed in an ultra-compact 4-ball WCSP package measuring 0.63 mm x 0.63 mm. It delivers stable output with very low dropout for space-constrained portable and wearable applications. Available from stock worldwide with competitive pricing and fast shipping.

THS4082CDGN is a high-speed single-channel video amplifier from Texas Instruments in an 8-pin SOIC package. It delivers 175 MHz bandwidth and operates from ±5 V dual supply or a 10 V to 30 V single supply. Available from stock with worldwide shipping.

Digital Isolators General-purpose, quad-channel, 4/0 digital isolator

Switching Voltage Regulators SIMPLE SWITCHER power converter 4.2-V to 80-V, 2-A, synchronous buck with 40- uA IQ 8-SO PowerPAD -40 to 150

TPD1E1B04DPYR is a single-channel bidirectional TVS ESD protection diode from Texas Instruments with a 3.6 V standoff voltage and 8.5 V clamping voltage. It protects sensitive signal lines from ESD events in an ultra-compact 2-pin X1SON package measuring 0.62 mm x 0.62 mm. Available in tape-and-reel format with worldwide shipping.

Digital to Analog Converters - DAC 12B,Dual,Lo Pwr Ultra-Lo Glitch DAC

Translation - Voltage Levels 4-Bit Dual-Supply Bus Transceiver with Configurable Voltage Translation and 3-State Outputs 16-UQFN -40 to 85

LDO Voltage Regulators 1A LDO ADJ REG

HQCCN,

1• Operating temperature from –40°C to +125°C • Supports 5-V VCC operation • Inputs accept voltages to 5.5 V • Supports down translation to VCC • Max tpd of 3.4 ns at 3.3 V • Low power consumption, 10-µA max ICC • ±24-mA Output drive at 3.3 V • Typical VOLP (output ground bounce) <0.8 V at VCC = 3.3 V, TA = 25°C • Typical VOHV (output VOH undershoot) >2 V at VCC = 3.3 V, TA = 25°C • Ioff Supports live insertion, partial-power-down mode, and back-drive protection • Latch-up performance exceeds 1

Battery Management 750mA SGL-CHIP Li- Ion/Li-Pol Chg Mgmt

RF Microcontrollers - MCU SimpleLink&trade;&nbsp;32 -bit Arm&reg;&nbsp;Cortex&reg;-M4 single-protocol 2.4-GHz wireless MCU 48-VQFN -40 to 105

TL2575HV-33QKTTRQ1 is a fixed 3.3 V, 1 A step-down switching regulator from Texas Instruments with a wide input voltage range of 4.75 V to 60 V in a TO-263-6 surface-mount package, designed for automotive and industrial power conversion. Available from stock worldwide with competitive pricing.

TXU0304BQAR is a unidirectional 4-channel voltage level translator from Texas Instruments supporting data rates up to 200 Mbps across mismatched logic rails. It translates logic levels in a single direction with an active-high enable pin and operates in a compact 14-pin WQFN (3x2.5 mm) package. Available from stock with worldwide shipping.

Isolated Module DC DC Converter 1 Output 5V 200mA 4.5V - 5.5V Input, 1W , 200mA , 1kV , -40°C ~ 85°C