Texas Instruments

TPS79525DCQRG4

TPS79418DGNR is a 250 mA fixed-output low-dropout linear voltage regulator from Texas Instruments with a 1.8 V output, 0.9 V typical dropout voltage, and an input range of 2.7 V to 5.5 V. Housed in an 8-pin MSOP package, it suits portable electronics, microcontroller rails, and battery-powered sensor systems.

TPS51461RGET

The devices, which operate over an input range of 2.5 V to 24 V, are stable with any capacitor greater than or equal to 0.47 μF.

tralow 85µA Typical Quiescent Current a voltage-driven device, the quiescent current is very low and independent of output loading (typically 85µA • Fast Transient Resp

TPS752xxQ with RESET Output, TPS754xxQ with Power Good Output ST-TRANSIENT-RESPONSE 2-A LOW-DROPOUT VOLTAGE REGULATORS

TPS76815QPWPR is an automotive-grade fixed 1.5 V, 1 A low-dropout linear regulator with power-good and enable pins, operating from a 2.7 V to 10 V input with only 230 mV dropout at full load. Packaged in a 20-pin HTSSOP with exposed thermal pad, it targets automotive and industrial processor core supply rails.

The TPS723 low-dropout (LDO) negative voltage regulator offers an ideal combination of features to support low noise applications. This device is capable of operating with input voltages from –10 V to –2.7 V, and support outputs from –10 V to –1.2 V. This regulator is stable with small, low-cost ceramic capacitors, and include enable (EN) and noise reduction (NR) functions. Thermal short-circuit and over-current protections are provided by internal detection and shutdown logic. High PSRR (65 dB at

The TPS62175DQCR/BKN is a high-efficiency synchronous step-down (buck) DC-DC converter capable of accepting input voltages up to 28 V and delivering up to 500 mA output current with an adjustable output voltage down to 0.9 V. It features a proprietary SNOOZE mode for ultra-low quiescent current at light loads, enabling high efficiency across a wide load range in a compact small-outline no-lead package. Designed for industrial, building automation, and wide-input-range power systems requiring efficient 24 V bus step-down regulation.

1.5-A, ultra-low-dropout voltage regulator with low-IQ & power good

1.5-A, ultra-low-dropout voltage regulator with low-IQ & power good

GREEN, PLASTIC, HTSSOP-20

LDO Voltage Regulators 3A LDO w/ Prog Soft-Start

Switching Voltage Regulators Reg 3.3-V 50-mA Charge Pump

LDO Voltage Regulators 3A LDO w/ Prog Soft-Start

TPD4S009 4-Channel ESD Solution for High-Speed Differential Interface

Supervisory Circuits 220nA w/ 10ms/200ms Select delay time

LDO Voltage Regulators Sgl Output,1.5A LDO Linear Reg

TPS54352PWPRG4 is a synchronous step-down (buck) PWM switching regulator from Texas Instruments, capable of delivering 3 A output current from a 4.5 V to 20 V input voltage range. It uses voltage-mode control with integrated high-side and low-side MOSFETs, enabling high efficiency across a wide load range. Housed in a 16-pin HTSSOP package, it suits point-of-load power conversion in industrial, communications, and embedded computing systems.

Use the download button to access the TPS71718DCKR/BKN schematic symbol, PCB footprint, and 3D model.

1-A, ultra-low-dropout voltage regulator with reverse current protection & enable

TPS54680QPWPREP is an enhanced-product tracking synchronous buck PWM switcher by Texas Instruments accepting a 3 V to 6 V input with voltage-mode PWM control. Key specs: 5.5 V nominal input, 28-pin SOIC package, RoHS e4 compliant. From $3.80, in stock with worldwide shipping.

For 80-mA Rated Current and Higher Power.

Switching Voltage Regulators 6-A Act Bus Term/DDR DC/DC Converter

The TPS3860x0 family of supply voltage supervisors (SVSs) can monitor four power rails that are greater than 0.4 V and one power rail less than 0.4 V (including negative voltage) with a 0.25% (typical) threshold accuracy. Each of the four supervisory circuits (SVS-n) assert a RESETn or RESETn output signal when the SENSEm input voltage drops below the programmed threshold. With external resistors, the threshold of each SVS-n can be programmed (where n = 1, 2, 3, 4 and m = 1, 2, 3, 4L, 4H).

The TPS3808G18DBVR/BKN is a precision voltage supervisor from Texas Instruments in a SOT-23-6 package with a 1.8V threshold. It provides programmable delay and open-drain reset output for reliable microcontroller supervision. From $0.50, available in stock with worldwide shipping.

DSP or Microcontroller Applications • Notebook and Desktop Compu

The TPS22960 is a small low-rON dual-channel load switch with controlled turnon. The devices contain two P-channel MOSFETs that can operate over an input voltage range of 1.62 V to 5.5 V. Each switch is independently controlled by on/off inputs (ON1 and ON2), which are capable of interfacing directly with low-voltage control signals. In TPS22960 a 85-Ω on-chip load resistor is added for quick discharge when the switch is turned off.

Audio Amplifiers 15W Stereo Class-D Audio Power Amp

LP3984IMFX-1.5HALF is a 150 mA ultra-low-dropout LDO linear voltage regulator with a fixed 1.5 V output in a 5-pin SOT-23 package. It operates from a 2.5 V to 6 V input, features a 72 µA typical quiescent current, and requires only a 1 µF output capacitor, targeting portable consumer electronics and wireless module power supply applications.

IC AMP MPLEX AMP 20TSSOP

Dual-channel, voltage supervisor, ultra-low supply current

Supervisory Circuits Dl Volt Detector

General Purpose Amplifier 2 Circuit Rail-to-Rail 8-SOIC

The TPD2E001 is a two-channel Transient Voltage Suppressor (TVS) based Electrostatic Discharge (ESD) protection diode array. The TPD2E001 is rated to dissipate ESD strikes at the maximum level specified in the IEC 61000-4-2 Level 4 international standard.

texas

TLC7733MJGB is a single-channel voltage supervisor and power-on reset generator from Texas Instruments, specifically designed to monitor 3.3 V supply rails with a programmable time delay. Operating over the extended temperature range of -55°C to 125°C, it is housed in a ceramic 8-CDIP package for high-reliability applications. Suitable for military, aerospace, and industrial systems requiring robust power monitoring.

Use the download button to access the REF5030IDGKT/BKN schematic symbol, PCB footprint, and 3D model.

The TPD2E001 is a two-channel Transient Voltage Suppressor (TVS) based Electrostatic Discharge (ESD) protection diode array. The TPD2E001 is rated to dissipate ESD strikes at the maximum level specified in the IEC 61000-4-2 Level 4

TLC1543CDBR

4.5ns, Rail-to-Rail, High Speed Comparator with Shutdown

The TMP124AIDG4 is a programmable digital temperature sensor from Texas Instruments in a small SOIC package, delivering 12-bit resolution with ±1.5°C maximum accuracy and an SPI-compatible serial interface. It features programmable alert thresholds, surface-mount package dimensions of 4.9 mm × 3.9 mm × 1.75 mm, and is suited for industrial process monitoring, thermal management in servers, and embedded system temperature control.

Single-channel nano-power high-voltage comparator with open-drain output, 1.5 nA maximum bias current at 25°C, and 3.6 mV maximum input offset voltage in a 5-pin SOT-23 package. Designed for ultra-low-power threshold detection in battery-operated systems with wide supply voltage range. Suitable for level-crossing detection, window comparators, and power-good monitoring circuits.

Analog to Digital Converters - ADC 10-Bit 85 kSPS Serial Out

Audio Modulator 8 Channel 64-TQFP (10x10)

Operational Amplifiers - Op Amps JFET Input Low Power High Drive Quad

J-FET Amplifier 1 Circuit 8-SOIC

THS5671AIPWG4 is a 14-bit, 125 MSPS high-speed digital-to-analog converter from Texas Instruments, supporting parallel word binary and two's complement input formats, -1 V to 1.25 V analog output range, and 28-pin SOIC packaging for communications and signal synthesis applications.

TLK2521IPAP is a dual-channel multi-rate gigabit transceiver supporting serial data rates from 1.0 Gbps to 2.5 Gbps per channel, operating from a 2.5 V supply with integrated CDR and PLL for clock recovery, housed in a 64-pin PowerPAD TQFP package for high-speed backplane, Gigabit Ethernet, and SONET/SDH line card designs.

16-Bit 200KSPS ADC Serial Out, Auto PWRDN, Pseudo Differential Input