Texas Instruments

Buffers & Line Drivers Octal Buffer/Driver With 3-State Outputs

Current Sense Amplifiers 26V, dual channel, 350kHz current sense amplifier 8-WSON -40 to 125

Board Mount Temperature Sensors 0.75 C , Remote and Local Digital Temperature Sensor with Two-Wire Interface-Wire Interface 8-VSSOP 0 to 125

Texas Instruments SN75107BDRE4 is a dual-channel differential line receiver with a common strobe input, minimum 2 V output swing, and 75 µA maximum high-level input current. Housed in a 14-pin SOIC package with Pb-free JESD-609 e4 compliance. Available in stock with competitive pricing and worldwide shipping.

Clock Synthesizer/Jitter Cleaner Wide Rng Lo-Jitter Crys Osc Clock Gen

The BQ24262RGET is a single-input, single-cell switching Li-Ion battery charger IC from Texas Instruments with adjustable charge threshold and 0.12V recharge threshold voltage. It comes in a compact 24-pin QFN package and is RoHS and REACH compliant. Available in stock with worldwide shipping for portable charging applications.

Small 8-ch 12-bit analog-to-digital converter (ADC) with I2C interface, GPIOs, CRC and RMS module

Analogue Switch ICs 5-V, 2:1 (SPDT), 1-channel general-purpose analog switch with 1.8-V input logic

The SN74LVTH540NSRE4 is a 3.3V ABT octal bus buffer and line driver with 3-state outputs from Texas Instruments. It supports unidirectional data flow with dual active-low output enable, 50 pF load capacitance, and 64 mA sink current. Available in a 20-pin Small Outline package with worldwide shipping.

Current Sense Amplifiers 26V, dual channel, 350kHz current sense amplifier 8-WSON -40 to 125

Voltage References Lo-Vtg Adj Precision Shunt Regulator

LDO Voltage Regulators

Logic Gates Quad 2-Input Pos- NAND

Touch Screen Controllers 20-Bit 48-Ksps I2S Audio Codec

RS-232 Interface IC 3V-5.5V Sgl-Ch RS232 1Mbit Line Drvr/Rcvr

Clock Synthesizer/Jitter Cleaner Fully Int Lo-Jitter Crstal Osc Clock Gen

Audio A/D Converter ICs 24-bit 96kHz Stereo Audio DAC

Supervisory Circuits Low-power 3-pin voltage supervisor (reset IC) with active-low open-drain reset 3-SOT-23 -40 to 125

The UC2852D is a high power factor preregulator controller IC from Texas Instruments for active power factor correction. It uses current-mode PWM control and operates with an input voltage range of 12.5V to 30V in a compact 8-Pin SOIC package. Available from stock worldwide with fast shipping for energy-efficient power supply designs.

Switching Controllers Hi-Perf Current-Mode PWM Controller

TPS40091RHDTG4 is a high-current synchronous buck controller supporting up to 120 A output current, operating from 4.5 V to 15 V input with voltage-mode or current-mode PWM control in a 28-pin QFN package. Designed for high-density server, telecom, and industrial point-of-load DC-DC power supplies.

Texas Instruments XPS628502QDRLRQ1 is an AEC-Q100-qualified automotive step-down converter accepting 2.7 V to 6 V input and delivering up to 2 A output with current-mode PWM control in a compact SOT583-8 package, targeting in-vehicle infotainment and ADAS supply rails.

Digital to Analog Converters - DAC 16-Bit Quad Voltage Output

The UCC2305NG4 is a current-mode PWM fluorescent lamp controller from Texas Instruments in a 28-pin DIP package. It supports input voltages from 5V to 18V and provides integrated control for CCFL backlighting and general fluorescent lighting applications. Available from stock with worldwide shipping.

MCU 32-bit ARM Cortex M4F RISC 256KB Flash 1.2V/3.3V 144-Pin LQFP T/R

LDO Voltage Regulators

High Speed Operational Amplifiers Super-Fast Ultr-Lo- Distortion Hi-Speed

RS-422/RS-485 Interface IC Hi-Output Full-dplx Driver and Receiver

Buffers & Line Drivers Dual Buffer/Driver

LDO Voltage Regulators Obsolete, LTB expires Nov-02-2017

The PTPS7A2025PDBVR is a 300-mA ultra-low quiescent current LDO voltage regulator from Texas Instruments with high PSRR and low noise. It features a 2.8 V to 6 V input range, up to 6 V operation, and only 0.14 V maximum dropout voltage. Available in a compact SOT-23 5-pin package, ideal for battery-powered designs.

LM2902KAVQPWRG4Q1 is an AEC-Q100 Grade 1 automotive quad op-amp from Texas Instruments rated for ±16 V / 32 V supply and -40°C to 125°C operation. It provides 80 dB typical CMRR and 7 mV maximum offset voltage in a 14-pin TSSOP package for reliable in-vehicle analog signal processing.

TM4C1233H6PGEI7 is a 32-bit ARM Cortex-M4F microcontroller from Texas Instruments' Tiva C Series with hardware floating-point, DMA, and integrated ADC. It operates at up to 25 MHz in a quad flat package with JTAG boundary scan support. Available from Texas Instruments with worldwide distribution.

The UCC3919DG4 is a single-channel hot-swap voltage controller from Texas Instruments for 3V to 8V bus voltages in commercial temperature applications. It features an adjustable threshold, controls an external N-channel MOSFET for inrush current limiting, and operates from a 16-pin SOIC package. Available from stock with worldwide shipping.

Hot Swap Voltage Controllers 3-8V Single Commercial Temp.

Texas Instruments 5962-9680101VCA is a military-grade 6-element CMOS Schmitt trigger inverter in a hermetic ceramic 14-pin DIP package. Part of the AHCT/VHCT/VT family with 8 mA output drive and MIL-PRF-38535 qualification for aerospace applications. Available with worldwide shipping.

Hot Swap Voltage Controllers 3-8V Single Commercial Temp.

5962-7700801VCA is a military-grade quad voltage comparator from Texas Instruments in a 14-pin ceramic DIP package. It operates on ±15 V or 30 V single supplies with open-collector outputs, 2 mV maximum input offset voltage, and 0.025 µA bias current at 25°C. Available for worldwide distribution.

5962-8973401VCA is a 6-element CMOS ACT inverter IC by Texas Instruments in a 14-pin ceramic DIP package. Key specs: 6 independent inverters, 50 pF load capacitance, 24 mA output current. Available from stock with worldwide shipping.

5962-9950403VCA is a military-grade quad general-purpose op-amp from Texas Instruments with ±16V/32V supply range, 80 dB typical CMRR, and 0.1 µA max bias current in a hermetic 14-pin ceramic DIP package for high-reliability aerospace applications. From $18.00 in stock worldwide shipping.

5962-8762402VCA is a military-grade hex Schmitt-trigger inverter from Texas Instruments' AC-logic family, providing 6 independent inverting channels with hysteresis for noise-immune signal conditioning. It operates across a 2 V to 5.5 V supply range with 24 mA output drive and 50 pF load capacitance rating, housed in a hermetic 14-pin CDIP ceramic package for harsh-environment reliability. Ideal for space, aerospace, and defense systems requiring MIL-spec qualified logic in radiation-tolerant ceramic packaging.

5962-8405601VCA is a military-grade dual D-type positive-edge-triggered flip-flop IC in a 14-pin ceramic DIP package supporting operation up to 21 MHz. It belongs to the HC/UH logic family with 50 pF load capacitance rating and meets MIL-PRF-38535 specifications for high-reliability applications. Available in stock with worldwide shipping from authorized distributors.

Supervisory Circuits Low-power 3-pin voltage supervisor (reset IC) with active-low open-drain reset 3-SOT-23 -40 to 125

Use the download button to access the TLV803EA30DCKR schematic symbol, PCB footprint, and 3D model.

Supervisory Circuits Low-power 3-pin voltage supervisor (reset IC) with active-low open-drain reset 3-SOT-23 -40 to 125

Supervisory Circuits Low-power 3-pin voltage supervisor (reset IC) with active-low open-drain reset 3-SC70 -40 to 125

Supervisory Circuits Low-power 3-pin voltage supervisor (reset IC) with active-low open-drain reset 3-SC70 -40 to 125

RF System on a Chip - SoC 2.4 GHz Radio Xceiver

Voltage References

Supervisory Circuits Low-power 3-pin voltage supervisor (reset IC) with active-low open-drain reset 3-SOT-23 -40 to 125