Texas Instruments

TPS54339EDDA is a integrated circuit for board-level control by Texas Instruments. Key specs: SOIC package, 9 pins, -40°C to 85°C. From inquiry pricing, in stock with worldwide shipping.

Fully-Integrated, 8-Ch Ultrasound Analog Front End w/ Passive CW Mixer and Digital I/Q Demodulation

Texas Instruments TPS3828-33DBVTG4, Processor Supervisor 0 → 5.8 V, WDT, Reset Input, 5-Pin SOT-23

Low-Power Stereo DAC with 4 Outputs, HP/Speaker Amplifier and 3D Effects

Use the download button to access the CSD17575Q3 schematic symbol, PCB footprint, and 3D model.

36V, Low Power, RRO, General Purpose Operational Amplifier

Linear Voltage Regulators 12V 100mA Fixed Pos Voltage Regulator

Automotive Catalog Single Buffer/Driver With Open-Drain Output

Use the download button to access the CLVC8T245MRHLTEP schematic symbol, PCB footprint, and 3D model.

Precision Amplifiers 10MHz, CMOS, Zero-Drift, Zero-Crossover, True RRIO Precision Operational Amplifier 8-SOIC -40 to 125

CSD17578Q3A 30 V N-Channel NexFET™ Power MOSFET

TEXAS INSTRUMENTS - SN65LVDT2DBVTG4 - Differential Line Driver, 1 Drivers

8-Channel Linear LED Driver With PWM Dimming, Qualified for Automotive Applications

3-pin voltage supervisor (reset IC) with active-low and open-drain reset

Texas Instruments CD74HC4051EE4 is a high-speed CMOS 8-channel single-ended analog multiplexer/demultiplexer with 200 MHz bandwidth and up to 6 V input voltage, housed in a 16-pin DIP package. Its 8:1 configuration routes one of eight analog or digital signals to a common I/O, simplifying signal switching in audio, sensor, and data-acquisition systems.

Use the download button to access the MUX506IPWR schematic symbol, PCB footprint, and 3D model.

SOIC-16

Automotive 3MHz, Low-Power, Low-Noise, RRIO, 1.8V CMOS Operational Amplifier

The TPS610997YFFR is a synchronous boost converter with an ultra-low 800nA quiescent current, accepting a 0.7V to 5.5V input range with a 3.7V nominal rating, housed in a compact 6-pin DSBGA package for battery-powered wearables and IoT devices.

Use the download button to access the CSD18536KCS schematic symbol, PCB footprint, and 3D model.

Use the download button to access the CSD18535KCS schematic symbol, PCB footprint, and 3D model.

3-MHz, Low-Power, Internal EMI Filter, RRIO, Operational Amplifiers

Analog Switch ICs 1-Ohm SPST 5-V/3.3-V Sng-Ch Analog Switch

Three Phase Pre-Driver with Dual Current Shunt Amplifiers

TEXAS INSTRUMENTS - CSD23280F3T - MOSFET, P-CH, -12V, -1.8A, LGA-3

Switching Voltage Regulators TPS6125xA 3.8-MHz, 5-V / 4-A Boost in 1.2-mm x 1.3-mm WCSP

Quadruple Differential Line Receiver

Quadruple Differential Line Driver

Switching Voltage Regulators 15W Neg Out Pwr Mod w/ 4.5V-40V Input

Enhanced Product Dual 2-Input Positive-Nand Gate

DSBGA-8

0.7Vin Synchronous Boost Converter with 800 nA Ultra-Low Quiescent Current

Quad SPDT High-Bandwidth 10/100 Base-T Lan Switch Differential 8 to 4 Multiplexer/Demultiplexer

Use the download button to access the TPSM84A21MOJT schematic symbol, PCB footprint, and 3D model.

QFM-20

USB Charging Port Controller

16-bit Ultra-Low-Power Microcontroller, 32KB Flash, 1K RAM

Use the download button to access the TPD1E04U04DPLT schematic symbol, PCB footprint, and 3D model.

Low-Voltage 7-Bit I2C and SMBus LED Driver With Intensity Control and Shutdown

The BQ25895RTWR is a single-cell Li-ion battery charger IC from Texas Instruments using MaxCharge technology, delivering up to 5A fast charging and a 3.1A boost mode. It supports a 3.9V to 14V input range in a 24-pin QFN package.

Enhanced Product 3.3-V Full-Duplex Rs-485 Driver And Receiver

TPD1E1B04DPYT is a single-channel bidirectional TVS diode with a 6.4 V breakdown voltage and a 6.3 V maximum clamping voltage. It is packaged in a compact 2-pin SOD-523 footprint for tight PCB layouts. The device protects low-voltage I/O lines from ESD transients in portable consumer electronics and mobile accessories.

Use the download button to access the MUX507IPWR schematic symbol, PCB footprint, and 3D model.

25W Filter-Free Class-D Stereo Amplifier In Space Saving QFN

SIMPLE SWITCHER Power Converter 150 kHz 0.5A Step-Down Voltage Regulator

Audio Amplifiers High Performance, High Fidelity Rail-to-Rail Input/Output Audio Operational Amplifier 8-SOIC -40 to 85

400mA and 500mA Voltage Regulator

Use the download button to access the ISO7820LLDW schematic symbol, PCB footprint, and 3D model.

Use the download button to access the BQ24296MRGER schematic symbol, PCB footprint, and 3D model.

CSD13202Q2 is a Texas Instruments single N-channel power MOSFET. It delivers a 12V minimum drain-source breakdown voltage, 14.4A maximum drain current, and a low 0.0116Ω on-resistance with 20mJ avalanche energy rating. In stock, worldwide shipping.