Texas Instruments

Serializers & Deserializers - Serdes NRND, alternate is SCAN921224SLC/NOPB

High-Performance Current-Mode PWM Controller

Dual, Micropower, Push-Pull Outputs, LinCMOS™ Voltage Comparator

Serializers & Deserializers - Serdes NRND, alternate is SCAN921226HSM/NOPB

DVI/HDMI Switch 80-Pin TQFP T/R

Switching Controllers Low Power Dual Out Current Mode

Digital to Analog Converters - DAC SGL 14-/12-/10-bit 500 MSPS DAC

USB Power SW Hi Side/DIST Single 6.5V 0.1A to 1.1A 6-Pin SOT-23 T/R

USB Power SW Hi Side/DIST Single 6.5V 0.1A to 1.1A 6-Pin SOT-23 T/R

Power Switch ICs - Power Distribution Adj current Ltd Sw

The INA2133UG4 is a dual differential amplifier from Texas Instruments with a 1.5 MHz bandwidth, 80 dB minimum CMRR, and a fixed gain of 1 V/V in a 14-pin SOIC package. It is designed for accurate differential signal amplification in data acquisition, instrumentation, and bridge sensor conditioning applications.

Monostable Multivibrator Dual Retriggerable Mono Multivibrators

Adjustable, 400-mA, 95% Efficient Step-Down Converter, 15uA, ThinSOT-23

Texas Instruments SN74LV4066ADG4 is a quad single-pole single-throw (SPST) analog switch with 40dB off-state isolation, 180Ω maximum on-resistance, and 6Ω channel-to-channel resistance matching in a 14-pin SOIC package. Available from stock with worldwide shipping.

TEXAS INSTRUMENTS - SN74LVCU04APW. - IC, HEX INVERTER

80V, 15A precision integrated-shunt high-accuracy current sense amplifier w/ enhanced PWM rejection

4.5-V to 60-V input, 5-A, step-down DC-DC converter with Eco-mode™

Analog Comparators SINGLE CHANNEL AMP

Texas Instruments SN74HC05NSRG4 is a hex inverter with open-drain outputs from the HC/UH logic family, integrating 6 independent single-input inverter gates in a 14-pin SOP package. It operates with a 50 pF load capacitance rating and a maximum open-drain sink current of 4 mA per output, suitable for level translation and bus driving. Available from authorized distributors with worldwide shipping.

Texas Instruments TPS51220RHBRG4 is a dual-output synchronous step-down PWM controller supporting a 4.5 V to 28 V input range in a thermally efficient 32-pin VQFN package. It operates in current-mode control with pulse-width modulation for precise, stable dual-rail regulation up to high switching frequencies. Available from stock worldwide with fast shipping.

Adjustable 500-mA low-dropout (LDO) regulator

4.5 V to 18 V input, dual 2 A output, synchronous step-down converter, with 1 ms fixed soft start

Switch Mode Secondary Side Post Regulator PWM Controller 500kHz 20-Pin PLCC T/R

2.2MHz wide VIN non-synchronous boost controller

Texas Instruments OPA2677IDDARG4 is a dual current-feedback operational amplifier with 2000 MHz bandwidth in an 8-pin HSOP EP package designed for ADSL line driving. Available from stock with worldwide shipping.

ADSL Driver Dual 2000MHz 8-Pin SOIC Tube

Analog Comparators Dual Micropower Push-Pull Output

16-bit Microcontrollers - MCU Ultra low power Micro Controller

The UCC3917DTRG4 is a single-channel positive floating hot-swap voltage controller from Texas Instruments with adjustable current and voltage thresholds, designed for safe board insertion and removal in live backplane systems. Packaged in a 16-pin SOIC with commercial temperature range. Available from stock with worldwide shipping.

Switching Voltage Regulators COMMERCIAL VERSION OF TPS54540BQDDAQ1

Dual Transmitter/Receiver RS-232 16-Pin SOIC Tube

The UCC3917D is a hot swap voltage controller from Texas Instruments in a 16-pin SOIC package. It manages positive floating supply rails with adjustable current limiting and fault protection. Available with commercial temperature rating for industrial power management designs.

Bus Transceivers 3.3-V ABT Octal Bus Trncvr W/3-St Otpt

The TLV431CDBVT is an adjustable precision shunt voltage regulator from Texas Instruments with 1.5% initial accuracy and a reference voltage range of 1.24 V to 6 V. Housed in a 5-pin SOT-23 surface-mount package, it operates with a cathode current of 80 µA to 15 mA over a 0 °C to 70 °C temperature range. Suited for feedback control in switched-mode power supplies, voltage monitoring, and precision reference circuits.

Power Switch ICs - Power Distribution 40-V, 8-mOhm, 1-Ch smart high-side switch

TLC7135CNG4 is a 4.5-digit dual-slope integrating ADC with 1-channel analog input, accepting -3 V to +6 V analog range and operating from ±5 V supplies. Its dual-slope conversion architecture delivers high noise rejection at 0.003 kSPS throughput. The 28-pin PDIP package suits precision bench instruments, digital panel meters, and laboratory measurement equipment.

DIP, DIP14,.3

High Speed Operational Amplifiers 1.8GHz Current Feedback Amplifier

IC OPAMP GP 2 CIRCUIT 8SOIC

OP Amp Dual GP R-R I/O ±8V/16V 8-Pin SOIC Tube

Comparator Single 8-Pin SOIC T/R

Use the download button to access the TL3016IPWR schematic symbol, PCB footprint, and 3D model.

High accuracy 3.3 V or 5 V digital PWM-output Hall effect sensor family

High Speed Operational Amplifiers 1.8GHz Current Feedback Amplifier

OP Amp Single Current Fdbk ±7.5V/15V 8-Pin VSSOP T/R

The THS4140IDGN is a 160 MHz fully differential input/output operational amplifier from Texas Instruments featuring voltage-feedback architecture with a high slew rate and shutdown capability. It delivers 75 dB minimum CMRR and 15 µA max input bias current in a compact small outline package. Available in stock worldwide with competitive pricing.

Use the download button to access the THS3111IDG4 schematic symbol, PCB footprint, and 3D model.

Operational Amplifiers - Op Amps 1MHz 45uA RRIO Quad Op Amp

16-bit Microcontrollers - MCU 48kB Flash 2MB RAM 12-Bit ADC/Dual DAC

Latch Transparent 3-ST 8-CH D-Type 20-Pin TSSOP T/R