Texas Instruments

High Speed Operational Amplifiers 210-MHz, 250-mA high-speed buffer 8-SON -40 to 125

Operational Amplifiers - Op Amps 40-V, single 3.5-MHz, RRO, MUX-friendly operational amplifier for cost-sensitive systems 5-SOT-23 -40 to 125

LIN Transceivers Fault-protected automotive local interconnect network (LIN) transceiver for K-line 8-SON -40 to 125

USB Interface IC Dual 3-A USB Type-C charging ports controller with programmable current limit and load shedding 25-VQFN-HR -40 to 125

Supervisory Circuits Nanopower high-input voltage supervisor with manual reset and programmable-reset time delay 5-SOT-23 -40 to 125

Supervisory Circuits Nanopower high-input voltage supervisor with manual reset and programmable-reset time delay 5-SOT-23 -40 to 125

Gate Drivers ±10-A 5.7-kV RMS single channel isolated gate driver with overcurrent protection 16-SOIC -40 to 125

RF System on a Chip - SoC Single-chip 60-GHz to 64-GHz intelligent mmWave sensor integrating processing capability 161-FC/CSP -40 to 105

UCC21732 10 A Source Sink Reinforced Isolated Single Channel Gate Driver for SiC IGBT with Active Protection Isolated Analog Sensing

Operational Amplifiers - Op Amps Quad 1-MHz, 40-V rail-to-rail input/output, low-offset-voltage, low-power op amp

Power Management Specialised - PMIC 40-V, 35-m , 1-ch automotive smart high-side switch with adjustable current limit 16-HTSSOP -40 to 125

H-Bridge Motor Driver 24-Pin VQFN EP T/R

Use the download button to access the SN74HCS367QPWRQ1 schematic symbol, PCB footprint, and 3D model.

LDO Voltage Regulators Automotive 500-mA, 40-V, ultra-low-IQ, low-dropout (LDO) linear regulator with power good 8-SO PowerPAD -40 to 150

Supervisory Circuits Current/Supply-Volt Supervisory

SN74HCS16507 8 Bit Parallel Load Shift Registers with Open Drain Outputs

LDO Voltage Regulators Automotive 500-mA, 40-V, low dropout (LDO) regulator with power good 8-SO PowerPAD -40 to 150

LDO Voltage Regulators Automotive 500-mA, 40-V, ultra-low-IQ, low-dropout (LDO) linear regulator with power good

Battery Management 3-4-Cell Lithium-Ion Protection IC

The UCC3957MTR-1G4 is a 3-to-4 cell lithium-ion battery protection IC with selectable cell count and overcurrent protection. It monitors up to four cells with adjustable thresholds and features a 16-pin SSOP package. Available from authorized distributors with worldwide shipping.

Battery Management 3-series to 10-series multicell battery monitor and protector

The UCC3957M-4 is a 3/4-cell lithium-ion battery protection IC from Texas Instruments in a 16-pin SOIC package. It provides overcurrent, overvoltage, and undervoltage protection for selectable 3 or 4-cell Li-ion battery packs. Available from authorized distributors with worldwide shipping.

The UCC3957MTR-2G4 is a 3–4 cell lithium-ion battery protection IC from Texas Instruments in a 16-pin SSOP package. It provides selectable three or four cell operation with overcurrent protection and 4-channel monitoring, safeguarding Li-ion battery packs in portable and industrial applications. Available in tape and reel.

Use the download button to access the TPSM41625MOVR schematic symbol, PCB footprint, and 3D model.

The UCC3957M-2 is a lithium-ion battery protection IC from Texas Instruments supporting selectable 3 or 4-cell pack configurations with overcurrent, overvoltage, and undervoltage protection for up to 4 cells. It features cell balancing and is housed in a 16-pin SSOP package for compact battery management system designs. Available from $1.20 in stock with worldwide shipping.

Switching Voltage Regulators 2.4-V to 5.5-V input, 3-A step-down converter with forced PWM in 1.5-mm 1.5-mm QFN package

Switching Voltage Regulators 1.8-V to 5.5-V input, tiny, 0.6-A, ultra-low Iq step-down buck converter with I2C/VSEL interface

SOT-583, 8 PIN

Use the download button to access the LV14360PDDAR schematic symbol, PCB footprint, and 3D model.

TEXAS INSTRUMENTS - SN74AHCT595N . - Shift Register, AHCT Family, 74AHCT595, Serial to Parallel, 1 Element, 8 bit, DIP, 16 Pins

Use the download button to access the TPS628601YCHR schematic symbol, PCB footprint, and 3D model.

Use the download button to access the TPS7B8350QDCYRQ1 schematic symbol, PCB footprint, and 3D model.

Buffers & Line Drivers Automotive Schmitt-trigger inputs quadruple bus buffer gates with 3-state outputs 14-SOIC -40 to 125

MOSFET -20V, P-channel NexFET Pwr MOSFET

Use the download button to access the LM2679T-12/NOPB schematic symbol, PCB footprint, and 3D model.

Use the download button to access the AWR2243ABGABLQ1 schematic symbol, PCB footprint, and 3D model.

The SM73302MFE/NOPB is a precision, low-noise, 88 MHz CMOS-input operational amplifier from Texas Instruments in a 5-pin SOT-23 package. It features voltage-feedback architecture with 85 dB minimum CMRR, extremely low bias current of 0.1 pA, and 1.8V CMOS-compatible input structure. Ideal for low-power precision signal conditioning, sensor amplification, and portable instrumentation where minimal noise and high accuracy are essential.

The SM73302MFX/NOPB is an 88 MHz precision CMOS operational amplifier from Texas Instruments with ultra-low input bias current, 1.8V supply operation, 100 dB typical CMRR, rail-to-rail input/output, and 5-pin SOT-23 package. In stock with worldwide shipping.

The INA281B3IDBVR is a high-voltage, wide-bandwidth current sense amplifier from Texas Instruments supporting -4V to 100V common-mode input range and 1 MHz bandwidth, in a 5-pin SOT-23 package. It features 120 dB minimum CMRR and transconductance architecture for accurate current measurement across high-voltage shunt resistors. Ideal for motor drives, battery management systems, and industrial power monitoring requiring precision over-current detection.

Use the download button to access the SN74HCS238PWR schematic symbol, PCB footprint, and 3D model.

Use the download button to access the TPS563207SDRLR schematic symbol, PCB footprint, and 3D model.

TMP64 ±1% 47 k u2126 Linear Thermistor With 0402 Package

Motor Drives 35-V, 1.5-A bipolar stepper driver with integrated current sensing & 1/256 microstepping

F28388DPTPSR C2000™ 32-bit MCU w/ connectivity manager, 2x C28x+CLA CPU, 1.5-MB flash, FPU64, CLB, ENET, EtherCAT

GREEN, PLASTIC, MS-012AB, SOIC-14

32-bit Microcontrollers - MCU Automotive C2000 32-bit MCU with 100 MHz, FPU, TMU, 128-KB flash, CLB 48-LQFP -40 to 125

The OPA4234UAE4 is a quad low-power precision single-supply operational amplifier from Texas Instruments, featuring 250 µV max offset voltage, 91 dB min CMRR, 0.05 µA bias current, and 14-pin SOIC package for accurate signal conditioning from -40°C to 85°C. In stock worldwide.

Analog Comparators Automotive 18-V comparator with integrated reference 6-WSON -40 to 125

Audio Power OpAmps WQFN-16 RoHS

PTC (Positive Temperature Coefficient) Thermistors Automotive grade, silicon-based linear thermistor with a positive temperature coefficient (PTC) 2-SOT-5X3 -40 to 125