Texas Instruments

The TPS7A1119PYKAR is a 500 mA ultra-low quiescent current LDO regulator from Texas Instruments with a 0.75 V minimum input voltage, 100 mV typical dropout voltage, and enable pin, operating from -40°C to 125°C in a tiny 5-ball DSBGA package. Its ultra-low IQ makes it ideal for always-on battery-powered subsystems. Available from stock with worldwide shipping.

LDO Voltage Regulators Automotive, adjustable- and fixed-output, 500-mA, 16-V, positive-voltage, LDO linear regulator 8-SON -40 to 150

Hall Effect Sensor Latch 3.3V/5V/9V/12V/15V/18V/24V T/R

Use the download button to access the SN74HCS238QDRQ1 schematic symbol, PCB footprint, and 3D model.

Switching Voltage Regulators 18.5-V output, 4.8-A synchronous boost converter with load disconnect 16-WQFN -40 to 125

Encoders, Decoders, Multiplexers & Demultiplexers

Encoders, Decoders, Multiplexers & Demultiplexers Dual 4-to-1 multiplexer with Schmitt-trigger inputs 16-SOIC -40 to 125

Encoders, Decoders, Multiplexers & Demultiplexers 3-to-8 line decoder demultiplexer inverting and non-inverting

LDO Voltage Regulators Automotive adjustable- and fixed-output, 1-A, 16-V, positive-voltage low-dropout linear regulator 8-SON -40 to 150

Operational Amplifiers - Op Amps Low-Power JFET-Input Op Amp

UC3826DW is a current-mode PWM switching controller from Texas Instruments, supporting 10 V to 20 V input range with 250 mA gate-drive output. Designed for high-frequency DC-DC converters in an SOIC-24 package. From $2.50 in stock worldwide shipping.

Use the download button to access the SN74HCS151DR schematic symbol, PCB footprint, and 3D model.

Motor/Motion/Ignition Controllers & Drivers 35-V, 1.5-A bipolar stepper or dual brushed motor driver with integrated current sensing 24-VQFN -40 to 125

Operational Amplifiers - Op Amps Industry s lowest offset drift (12 nV/C, max), 36V, 5MHz, zero drift, MUX-friendly op amp

555 Type, Timer/Oscillator (Single) IC 100kHz 8-SOIC

Battery Management 3-s to 14-s high-accuracy battery monitor and protector for Li-ion, Li-polymer and LiFePO4 battery 48-TQFP -40 to 85

LDO Voltage Regulators Automotive 1-A, low-IQ, high-PSRR, low-dropout (LDO) voltage regulator with power good 8-SON -40 to 125

The LP5951MGX-1.3/NOPB is a fixed 1.3 V output low-dropout linear regulator from Texas Instruments with 200 mV typical dropout voltage, 1.8 V to 5.5 V input range, and a 5-pin SOT-23 package. It is RoHS compliant and suited for powering low-voltage digital ICs and RF modules from single-cell Li-ion or dual-cell battery sources. Available from global distributors with worldwide shipping.

Use the download button to access the SN74HCS157QDRQ1 schematic symbol, PCB footprint, and 3D model.

Serializers & Deserializers - Serdes 1M pixel ADAS 60-100MHz PCLK serializer 32-WQFN -40 to 105

Serializers & Deserializers - Serdes 1M pixel ADAS 60-100MHz PCLK serializer 32-WQFN -40 to 105

Use the download button to access the INA238AIDGST schematic symbol, PCB footprint, and 3D model.

Switching Voltage Regulators 3.8-MHz, 5-V / 4-A Boost in 1.2-mm x 1.3-mm WCSP 9-DSBGA -40 to 125

UC1875JQMLV is a phase-shift resonant PWM controller from Texas Instruments designed for high-efficiency DC-DC power conversion. Features voltage-mode control with 11V to 20V input range, resonant control technique, and 20-pin ceramic DIP package. In-stock globally with fast worldwide shipping for demanding power supply designs.

The ADS131A02 is a 2-channel, 24-bit, 128 kSPS simultaneous-sampling delta-sigma ADC from Texas Instruments, offering high-resolution analog-to-digital conversion with simultaneous multi-channel acquisition in a QFP package. It delivers exceptional dynamic range for precision measurement applications. Available in stock with worldwide shipping.

Use the download button to access the INA237AIDGST schematic symbol, PCB footprint, and 3D model.

Switching Voltage Regulators 5.5-V, 6-A synchronous step-down converter with I2C interface in 1.05-mm 1.78-mm WCSP package 15-DSBGA -40 to 125

Analog to Digital Converters - ADC

Use the download button to access the TLV7032DSGR schematic symbol, PCB footprint, and 3D model.

Use the download button to access the INA237AIDGSR schematic symbol, PCB footprint, and 3D model.

4-V to 16-V input, 6-A synchronous buck converter, 900-mV reference voltage, latch-off current limit

Driver 3.5A 2-OUT High and Low Side Half Brdg Tube

Supervisory Circuits Low-power voltage supervisor (reset IC) with active-low open-drain output,SOT-23

16-bit Microcontrollers - MCU 20 MHz MCU with 192KB Flash, 16KB SRAM, 12-bit ADC, Comparator, DMA, UART/SPI/I2C, 160 Seg LCD, USB, 113-NFBGA -40 to 85

Use the download button to access the TPS7A0318DBVR schematic symbol, PCB footprint, and 3D model.

mmWave Sensor Digital Output 1.2V Automotive 161-Pin FC/CSP T/R

LMR36503RFRPER

Voltage References 12-ppm/ C low-noise low-power precision voltage reference

Texas Instruments TLC4502MJGB is a dual chopper-stabilized operational amplifier with 60 pA maximum input bias current and 100 dB typical CMRR in a ceramic DIP package. Its auto-zero architecture delivers near-zero offset drift over temperature, making it ideal for precision DC measurement in military and high-reliability applications. Available from stock with worldwide shipping.

LDO Voltage Regulators Automotive, adjustable- and fixed-output, 500-mA, 16-V, positive-voltage, LDO linear regulator 8-SON -40 to 150

16-bit Microcontrollers - MCU 20 MHz MCU with 256KB Flash, 16KB SRAM, 12-bit ADC, Comparator, DMA, UART/SPI/I2C, 160 Seg LCD, USB, 113-NFBGA -40 to 85

The TLV61046A is a 28 V output boost converter with an integrated power diode and isolation switch, operating from inputs as low as 0.7 V in a 6-pin SOT-23 package. It targets single- and dual-cell alkaline or NiMH battery applications requiring a boosted rail up to 28 V with automatic input isolation. Available from stock with worldwide shipping.

Clock Drivers & Distribution 1:10 LVPECL/HSTL to LVPECL Clock Driver

The TPS7B8850QKVURQ1 is an automotive-qualified, 500 mA, 40 V low-dropout linear regulator from Texas Instruments with fast transient response and a fixed output. It accepts a 6 V to 40 V input range with a 0.575 V maximum dropout voltage, operating from -40°C to 125°C in a TO-252 package.

LMV934Q1MT/NOPB is a quad automotive-grade rail-to-rail input/output op-amp from Texas Instruments operating from 2.7V to 5.5V single supply with 60dB minimum CMRR in a 14-pin TSSOP package. AEC-Q100-qualified for automotive signal conditioning, sensor interfaces, and control loop circuits in harsh environments.

Counter Shift Registers 8-bit parallel-load shift registers 16-SOIC -40 to 125

Op Amp Quad Low Power Amplifier R-R I/O 5.5V 14-Pin TSSOP T/R

Battery Management Cost-Efficient Coulomb Counter

32-bit Microcontrollers - MCU C2000 Enhanced Product 32-bit MCU with 60 MHz, 128 KB flash, CLA 80-LQFP -55 to 125

Use the download button to access the TMP100MDBVREP schematic symbol, PCB footprint, and 3D model.