Microchip

Microchip MCP1825S-3302E/AB is a fixed 3.3 V LDO linear regulator delivering up to 500 mA output current with only 0.35 V maximum dropout voltage and 6 V maximum input, housed in a TO-220-3 package for low-noise power supply designs.

The Microchip MCP8026-115E/PT is a 3-phase brushless DC motor controller IC integrating gate drivers for six external power MOSFETs and a peak output drive current of 0.5 A. It provides hall-sensor commutation, overcurrent protection, and fault reporting in a 48-pin TQFP package. The device is RoHS-compliant and targets BLDC motor drives for appliances, fans, and industrial automation equipment.

MCP2021A-330E/SN is a LIN transceiver with integrated 3.3 V LDO regulator from Microchip, compliant with LIN 2.x and SAE J2602 standards, featuring up to 20 kbps data rate and packaged in an 8-pin SOIC for automotive body-control and sensor node applications.

MCP2021A-330E/MD is a fully integrated LIN transceiver with a built-in 3.3 V LDO voltage regulator from Microchip, combining bus interface and local power supply in a compact 8-lead DFN package for automotive and industrial network nodes.

The MCP2021A-500E/SN is a LIN bus transceiver with integrated voltage regulator from Microchip Technology, supporting SAE J2602 at up to 20 kBd data rate. It provides a single-channel LIN physical layer interface and onboard 5 V regulator in an 8-pin SOIC package, ideal for automotive body electronics and slave node designs.

Microchip MCP2021A-500E/MD is a LIN 2.x compatible transceiver integrated with a 5.0 V LDO voltage regulator in an 8-pin DFN package, providing a single-chip solution for automotive LIN slave nodes that require bus communication and local power supply from a 12 V vehicle rail.

MCP79510-I/MS is a real-time clock/calendar IC with SPI interface, 64-byte SRAM, and EEPROM, supporting 1.8V to 5.5V supply and clock frequencies up to 32 kHz for time-keeping applications.

The MCP2221A-I/ML is a USB 2.0 full-speed to I2C/UART protocol converter IC from Microchip. Housed in a compact 16-pin QFN package, it provides USB-to-I2C, USB-to-UART, and GPIO bridging at up to 12 MHz, and is ideal for embedded debug interfaces and USB-to-serial adapters.

8-bit Microcontrollers - MCU AVR 32K FL 2K SRAM 1KB EE 20 MHZ GRN

Microchip MCP2021AT-500E/SN is a single-channel LIN bus transceiver operating at up to 20 kbps with a 12 V nominal bus voltage and integrated slope control. It is packaged in an 8-pin SOIC and targets automotive body electronics, HVAC, and low-speed node communication in LIN 2.x networks.

The PIC16F677-I/ML is an 8-bit CMOS microcontroller featuring 14 KB Flash memory, up to 20 MHz operation, and nanoWatt Technology for ultra-low power consumption. It integrates a 10-bit ADC, comparators, and USART communication in a compact 20-pin QFN package. Ideal for cost-sensitive embedded control applications requiring low power and analog capabilities.

Microchip PIC18F26K22-E/ML is an 8-bit PIC18 nanoWatt XLP microcontroller with 64 KB Flash and 3968 B RAM, running up to 64 MHz. It integrates an ADC, operates down to 2.3 V at 16 MHz, and comes in a VQFN-28 lead-free package.

The MCP2561-E/SN is a high-speed CAN (Controller Area Network) transceiver IC from Microchip, supporting data rates up to 1 Mbps, housed in an 8-pin SOIC package. It provides the physical layer interface between a CAN controller and the differential bus, with robust protection features for automotive and industrial reliability. Suitable for automotive ECUs, industrial networks, and embedded motor control systems.

Microchip MCP8026T-115H/PT is a 3-phase brushless DC motor gate driver with 0.5A gate drive output current in a 48-pin TQFP package. It integrates comprehensive protection and control features for sensorless or sensored BLDC motor applications. Available from stock worldwide with global shipping.

The Microchip MCP45HV51T-104E/ST is a single-channel, 8-bit volatile digital potentiometer with a 100 kΩ end-to-end resistance, controlled via a 2-wire I2C-compatible serial interface. Housed in a TSSOP-14 package, it supports high-voltage operation and targets industrial, audio, and calibration applications requiring software-adjustable resistance.

DIP-40

LEAD FREE, SOT-223, 4 PIN

Microchip MCP45HV51T-503E/ST is an 8-bit volatile digital potentiometer with a 50 kΩ resistance and 2-wire serial (I2C) control interface. It supports resistor array values of 5 kΩ, 10 kΩ, and 50 kΩ in a 14-pin TSSOP package, suitable for programmable gain and calibration applications.

MICREL SEMICONDUCTOR - MIC5014YN - MOSFET DRIVER, HIGH/LOW SIDE, DIP-8

PIC24FV32KA301-I/SO is a 16-bit PIC24F microcontroller with 32 KB Flash, 32 MHz max clock, and XLP ultra-low power technology in a 20-pin SOIC package. Ideal for battery-powered and IoT embedded designs.

Microchip PIC16F1614-I/ST is an 8-bit MCU in TSSOP-14 package, offering 7KB Flash, 512B RAM, 10-bit ADC, DAC channels, and 32 MHz max clock. From $0.80 in stock, worldwide shipping.

I2C-Compatible (2-wire) Serial EEPROM

Microchip MCP1754ST-3302E/CB is a fixed 3.3 V, 150 mA LDO linear regulator in 3-pin SOT-23A package with 0.5 V maximum dropout and 2% output accuracy. Suited for battery-powered and space-constrained embedded applications.

The 24LC08B/P is an 8 Kbit I2C serial EEPROM from Microchip, supporting 400 kHz clock, 16-byte page writes, 1 million write/erase cycles, and 200-year data retention on a 2.5V to 5.5V supply. Available in an 8-pin PDIP package for embedded configuration storage worldwide.

TO-263, 5 PIN

QFN-16

LQFP-100

PIC24FV32KA301-I/P is a 16-bit PIC24 microcontroller by Microchip with 32 KB Flash, 32 MHz clock, and an integrated ADC in a 20-pin PDIP package. Key specs: 2 V to 3.6 V supply range, 16 MIPS performance, and low-power sleep modes for battery applications. Available from stock worldwide.

MCP1754ST-5002E/CB is a fixed 5 V, 150 mA LDO linear voltage regulator from Microchip with a maximum input voltage of 16 V and a nominal dropout of 300 mV. Packaged in a 3-pin SOT-23A, it offers ±2% output accuracy and suits low-power industrial and consumer regulation tasks where compact size is essential.

8-bit Microcontrollers - MCU 16KB Flash 768b RAM SERIAL EE IND

0.300 INCH, GREEN, PLASTIC, MS-001BA, DIP-8

The MCP4018T-503E/LT is a single-channel 50 kΩ digital potentiometer from Microchip Technology with 128 wiper positions and a 2-wire I2C-compatible serial interface. It operates over a wide supply voltage range, is packaged in a 6-pin SOT-23 for minimal board space, and is RoHS-compliant.

MCP4542-103E/MS is a single 7-bit digital potentiometer from Microchip with non-volatile memory, 10 kΩ end-to-end resistance, I2C interface with increment/decrement control, and an 8-pin MSOP package for programmable gain, offset, and bias adjustment applications.

Microchip MCP1754T-3302E/OT is a fixed 3.3V LDO linear regulator with 150 mA output current and a 300 mV typical dropout voltage in a 5-pin SOT-23 package. Operating from 3.6V to 16V input, it delivers a stable regulated output across -40°C to +125°C, suited for portable and industrial power supplies.

Microchip Technology MIC3775YMM, LDO Regulator, 750mA Adjustable, 1.24 → 6 V, ±2% 8-Pin, MSOP

Microchip 25AA256-I/P is a 256Kbit SPI bus serial EEPROM in an 8-lead plastic DIP package supporting clock frequencies up to 10 MHz. It features 1,000,000 write/erase cycle endurance and 200-year data retention for reliable non-volatile storage. Available from authorized distributors with worldwide shipping.

MCP3208T-BI/SL is a 12-bit successive-approximation ADC from Microchip with 8 channels and SPI interface, offering 6 µs maximum conversion time and 5 V analog input range in a SOIC-16 package with worldwide shipping.

Microchip PIC16F917-I/P is an 8-bit PIC16 family microcontroller running at up to 20 MHz with integrated ADC and wide supply range from 2 V to 5.5 V. It is housed in a 40-pin 0.600-inch DIP package ideal for breadboard prototyping and through-hole assembly. Available in RoHS-compliant lead-free finish for low-to-medium volume embedded control applications.

The Microchip MCP4802-E/SN is a dual-channel 8-bit digital-to-analog converter with SPI serial interface in an SOIC-8 package. It provides two independent analog output channels with a maximum output of 4.176 V using binary-coded serial input. Suitable for waveform generation, programmable bias references, and analog signal control in embedded systems.

Microchip PIC16F18313-E/RF is an 8-bit PIC microcontroller featuring 3.5 KB Flash, 256 bytes RAM, and 256 bytes EEPROM, operating up to 32 MHz. It includes a 10-bit ADC, DAC, comparators, and enhanced peripherals for versatile embedded control. Ideal for IoT sensors, home appliances, and low-power industrial applications with wide voltage operation from 1.8 V to 5.5 V.

The MCP4442-502E/ST is a 4-channel, 129-position, 5 kΩ non-volatile digital potentiometer with I2C (2-wire) serial interface, operating up to 2 kHz bandwidth, housed in a 14-pin TSSOP package for precise programmable resistance in compact designs.

Microchip LAN9252/ML is a 2-3 port EtherCAT slave controller with integrated Ethernet PHYs in a 64-pin QFN package, supporting SPI and I2C host interfaces. It delivers up to 12.5 MBps data transfer with 25 MHz clock and 16-bit address bus for industrial real-time networking. Available from authorized distributors worldwide with standard lead times.

The MCP1754ST-3302E/MB is a fixed 3.3 V, 150 mA low-dropout linear voltage regulator from Microchip Technology with ±0.4% output accuracy and a wide input range of 3.6 V to 16 V. It features a typical dropout voltage of 0.3 V and is housed in a 3-pin SOT-89 package for industrial and commercial power supply designs.

PIC18F242-I/SP is an 8-bit PIC18 microcontroller with 40 MHz max clock, integrated ADC, and operation down to 2V. It features a 28-pin skinny DIP package making it easy to prototype and breadboard. Available from stock with worldwide shipping.

DIP-40

IC RESET MONITOR 4.00V

Use the download button to access the ATXMEGA384D3-AU schematic symbol, PCB footprint, and 3D model.

Microchip PIC16F1613-I/P is an 8-bit PIC16 microcontroller with 3.5 KB Flash, 32 MHz clock, integrated ADC and DAC, operating from as low as 2.3 V in a 14-pin PDIP package. Suitable for cost-sensitive embedded applications. Available in stock worldwide with fast shipping.

Use the download button to access the USB3320C-EZK schematic symbol, PCB footprint, and 3D model.

UDFN-8