Integrated Circuit

Motor / Motion / Ignition Controllers & Drivers 40-V max, 8-A peak, sensorless trapezoidal control 3-phase BLDC motor driver

Motor / Motion / Ignition Controllers & Drivers Automotive 12-V battery, sensorless sinusoidal control 3-phase BLDC motor driver 24-HTSSOP -40 to 125

Power Switch ICs - Power Distribution 5.5-V, 6-A, 8.7-mΩ load switch with adjustable rise time and adjustable quick output discha 8-WQFN-HR -40 to 125

Single-channel eFUSE power protection IC with 4.5 V to 58 V input range, adjustable current limit threshold, and fault management in a 20-pin HTSSOP package. Provides overcurrent, overvoltage, and thermal protection for industrial and telecom power rails. Available in stock worldwide with fast global shipping.

Texas Instruments TLV9351QDBVRQ1 is an AEC-Q100 automotive single-channel op amp with 3.5 MHz bandwidth, 40 V supply range, and rail-to-rail output swing in a 5-pin SOT-23 package. Offers 95 dB CMRR and MUX-friendly input architecture for precision signal conditioning. Available from stock with worldwide shipping.

TLV7042QDGKRQ1 is a dual automotive-grade analog comparator with open-drain output, 2-nA typical bias current, 8 mV maximum input offset voltage, and AEC-Q100 qualification in an 8-pin VSSOP package. Available from stock worldwide with fast shipping.

32-bit Microcontrollers - MCU C2000 32-bit MCU 120-MHz 384-KB flash, FPU, TMU with CLA, CLB, AES and CAN-FD 80-LQFP -40 to 125

Operational Amplifiers - Op Amps Quad, 5.5-V, 1-MHz, 4-mV offset voltage, RRO operational amplifier 14-SOT-23-THIN -40 to 125

Use the download button to access the F280039CSPZ schematic symbol, PCB footprint, and 3D model.

Battery Management Single Cell Li-Ion Charger

Buffers & Line Drivers Octal buffers and line drivers with 3-state outputs and Schmitt trigger inputs 20-VQFN -40 to 125

Monostable Multivibrator 13 ns 16-VQFN (4x3.5)

Fuel Gauge Li-Ion/Li-Pol 12-Pin VSON EP T/R

TPSM63606RDLR is a high-density 6 A DC/DC power module from Texas Instruments accepting 3 V to 36 V input and delivering 1 V to 16 V output with current-mode PWM control in a compact 5 mm x 5.5 mm enhanced HotRod QFN package. Integrates inductor and controller for minimal external components. In stock globally with worldwide shipping.

TPS929121AQPWPRQ1 is an AEC-Q100-qualified automotive 12-channel high-side LED driver from Texas Instruments with a 40 V input voltage rating and FlexWire single-wire diagnostic interface. It supports independent PWM dimming on each of the 12 channels for precise automotive exterior and interior lighting control. Available in a 24-pin HTSSOP package with worldwide shipping.

RF Detector 50 MHz to 4 GHz 40 dB Logarithmic Power Detector for CDMA and WCDMA 6-DSBGA -40 to 85

The TMCS1108A4BQDRQ1 is an AEC-Q100 automotive-grade isolated Hall-effect current sensor from Texas Instruments, offering ±100 V isolation and analog voltage output in a compact 8-pin SOIC package rated from -40 °C to 125 °C. It provides precise, non-intrusive current measurement for automotive and industrial applications. Available in stock worldwide with competitive pricing and fast global shipping.

TL431CLPRE3 is an adjustable precision shunt voltage reference IC with 2.2% initial accuracy and output voltage range from 2.5V to 36V. Operates as a two-terminal programmable zener replacement in 3-pin TO-92 through-hole package. Available from Texas Instruments in stock with worldwide shipping.

Logic Gates Quad 2-Input

THVD1406DRLR is a 3.3 V to 5 V half-duplex RS-485 and RS-422 transceiver IC with auto-direction control and 12 kV IEC 61000-4-2 ESD protection in an 8-pin SOT-23 flat lead package supporting up to 500 kbps data rate. It eliminates DE/RE direction control signals in half-duplex networks, simplifying firmware. Available in stock with worldwide shipping from authorized distributors.

TMS4C1024-80N is a 1 Mbit Fast Page Mode DRAM from Texas Instruments with a maximum access time of 80 ns and a 1-bit wide data bus. It supports RAS-only, CAS-before-RAS, and hidden refresh modes in an 18-pin DIP package. Available in stock worldwide for legacy system maintenance and vintage computer repair.

LFBGA, BGA423,24X24,25

Use the download button to access the BQ24010DRCR schematic symbol, PCB footprint, and 3D model.

evice is characterized for operation from –40°C to 85°C. ... The CDCLVP111 clock driver distributes one differential clock pair of LVPECL input, ( .

The SN74HC238N is a 3-line to 8-line decoder with active-high outputs in the high-speed HC CMOS logic family. It operates from 2 V to 6 V supply and decodes 3 binary address inputs into 8 mutually exclusive output lines with enable control. Available in a 16-pin DIP package for through-hole address decoding and memory bank selection.

TUSB1210-Q1 is an automotive-qualified USB 2.0 ULPI transceiver from Texas Instruments supporting high-speed 480 Mbps and full-speed 12 Mbps operation with a ULPI interface for connection to application processors. It is packaged in a compact QFN for space-constrained automotive designs. Available from authorized distributors with worldwide shipping.

Use the download button to access the ISO6763DWR schematic symbol, PCB footprint, and 3D model.

Use the download button to access the DRV8231ADSGR schematic symbol, PCB footprint, and 3D model.

Differential Amplifiers High-precision (40-uV offset), 2-MHz, 88-dB CMRR, low-power, e-trim difference amplifier

Translation Transceiver 2 Element 8 Bit per Element 3-State Output 24-VQFN (5.5x3.5)

Operational Amplifiers - Op Amps 40-V, single 10-MHz, rail-to-rail input/output, low-offset-voltage, low-noise op amp 5-SOT-23 -40 to 125

TCA6408ARGTR is a Texas Instruments 8-bit I2C I/O expander with 2-wire bus interface at up to 400 kHz, providing 8 configurable GPIO pins in a compact 16-pin QFN package. Supports 2-address selection via address pin and 1.65 V to 5.5 V supply voltage range. Available from stock with worldwide shipping.

Use the download button to access the BQ25180YBGR schematic symbol, PCB footprint, and 3D model.

Texas Instruments TPS40075RHLT is a voltage-mode PWM synchronous buck controller operating from 4.5 V to 28 V input in a 20-pin QFN package. Supports adjustable output and programmable frequency up to 1 MHz for compact power supplies. Available in stock worldwide with competitive pricing.

TPS62A01DRLR is a high-efficiency PWM step-down switching regulator from Texas Instruments supporting 2.5 V to 5.5 V input voltage with PSM control technique available, packaged in a compact 6-lead SOT-563 flat lead for space-critical portable and IoT applications. Available from stock worldwide with competitive pricing.

Use the download button to access the LM5168FDDAR schematic symbol, PCB footprint, and 3D model.

Operational Amplifiers - Op Amps Low Pwr Dual Op Amp

TL084HIDYYR is a quad JFET-input general-purpose operational amplifier with ±20 V dual-supply or 40 V single-supply operation in a 14-pin TSOT-23 package. It provides 0.00012 µA max bias current, 100 dB minimum CMRR, and wide bandwidth for precision signal processing. In stock worldwide with fast shipping.

TLE2024CDWG4 is a quad precision operational amplifier from Texas Instruments in a 16-pin SOIC package. It features 88 dB minimum CMRR, 0.09 µA maximum bias current, and voltage-feedback architecture for low-noise signal conditioning. Available from stock worldwide with competitive pricing.

Texas Instruments

The TMS5701227CZWTQQ1 is an automotive-grade 32-bit ARM Cortex-R4F microcontroller from Texas Instruments, clocked up to 80 MHz with integrated ADC, DMA, and boundary scan support. It is AEC-Q100 qualified for functional safety applications, packaged in a 337-ball BGA for high pin-count automotive system designs. Available worldwide for powertrain, chassis, and body control modules.

TPSM63603RDHR is a current-mode PWM switching regulator power module from Texas Instruments accepting 3 V to 36 V input with a 24 V nominal, integrating the controller and power stage in a 30-pin QFN module for compact industrial and automotive DC-DC step-down conversion. Available in stock with worldwide shipping.

Communication ICs - Various TONE DECODER

• Programmable voltage or current outputs with flexible configuration: – Voltage outputs: • 1 LSB INL and DNL (10-bit) • Gains of 1x, 1.5x, 2x, 3x, and 4x – Current outputs: • 1 LSB INL and DNL (8-bit) • Unipolar and bipolar output range options from 25 μA to 250 μA • 35-μA/channel IDD in voltage-output mode • Programmable comparator mode for all channels • High-impedance output when VDD is off • High-impedance and resistive pulldown powerdown modes

Analog to Digital Converters - ADC 12B ADC with Int MUX PGA Comp Osc and Ref

TPS25970ARPWR is a single-channel eFuse power protection IC with adjustable overvoltage and overcurrent thresholds supporting 2.7 V to 23 V input range in a 10-pin WSON package. Available in stock worldwide with fast shipping.

Digital Isolator Logic 6-CH 50Mbps Automotive AEC-Q100 16-Pin SOIC T/R

The TLV9361IDBVR is a single-channel, MUX-friendly operational amplifier from Texas Instruments with a 10 MHz gain-bandwidth product, 40 V rail-to-rail output swing, and 95 dB minimum CMRR in a compact SOT-23-5 package. It tolerates multiplexer-driven input steps without phase reversal, making it ideal for multichannel acquisition systems. Available from stock worldwide.

16-bit, 860-SPS, 4-channel, delta-sigma ADC with PGA, oscillator, VREF, temp sensor and SPI

Use the download button to access the ISO6761DWR schematic symbol, PCB footprint, and 3D model.