Integrated Circuit

The LTC2055 is a dual zero-drift precision operational amplifier with 3 µV maximum input offset voltage and rail-to-rail output swing in an MSOP-8 package. It features 115 dB minimum CMRR, 0.003 µA bias current, and 6V automotive-grade operation for precision signal conditioning. Available from authorized distributors with worldwide shipping.

Digital Signal Processors & Controllers - DSP, DSC 4th Gen High Perf 266MHz 5Mbits RAM

Precision Amplifiers 2x uP Zero-Drift Op Amps

Digital to Analog Converters - DAC IC 10-bit 4-ch SPI w/on chip ref

RF Detector 6GHz RMS Power Detector with 12-Bit Serial Output ADC

LTC2055HVIMS8#PBF is a dual zero-drift precision operational amplifier from Analog Devices with input offset voltage below 5 µV and CMRR of 130 dB typical, housed in an 8-pin MSOP package. Available from stock with worldwide shipping.

Analog Devices LT1358IN8#PBF is a dual voltage-feedback operational amplifier with 25 MHz bandwidth, 600 V/µs slew rate, and 2 mA supply current per amplifier in an 8-pin DIP package. Features 84 dB CMRR and 1500 µV max input offset voltage for high-speed analog signal processing. Suited for active filters, video signal amplification, and high-speed instrumentation.

Analog Devices LTC5594IUH#PBF is a high-linearity I/Q demodulator operating from 300 MHz to 9 GHz with integrated wideband IF amplifier in a 32-pin QFN package. From $18.00 in stock with worldwide shipping.

Supervisory Circuit with Watchdog, Active-Low Open-Drain and Active-High Push-Pull Reset Outputs

Analog Devices LTC2380CMS-24#PBF is a 24-bit successive approximation ADC achieving up to 2 Msps throughput with an integrated digital filter, supporting analog inputs from -2.5V to 5.1V for precision instrumentation and data acquisition systems.

Shunt Voltage Reference IC ±0.4% 8-SOIC

LTC6102HVIMS8#PBF is a high-voltage, zero-drift current sense amplifier in an SOIC-8 package. It features 50 µV maximum input offset voltage and operates from supply voltages up to 60 V. Available from Analog Devices with worldwide shipping.

Analog Comparators 4.5ns Single High Speed Comparator

The LT8608IDC#TRMPBF is a 42 V, 1.5 A peak synchronous step-down DC-DC converter from Analog Devices with a 3 V to 42 V input range and PWM current-mode control. It integrates high-side and low-side MOSFETs for efficient switching with minimal external components. Packaged in a compact 8-lead DFN for industrial, automotive, and telecom power supply designs requiring wide input range.

LTC6102HDD-1#PBF is a precision current sense amplifier from Analog Devices with a maximum input offset voltage of 50 µV, designed in an 8-DFN (3x3) package. It supports rail-to-rail output and operates from a wide supply voltage range, making it ideal for high-side current sensing in power management circuits. Available from major distributors with worldwide shipping.

Analog Devices LTC6259HDC#TRMPBF is a dual general-purpose voltage-feedback op-amp with 64 dB minimum CMRR and 0.075 µA maximum input bias current in an 8-pin DFN package. Ideal for precision signal conditioning, filtering, and sensor interface circuits requiring low offset and high common-mode rejection.

High Power, 88 W Peak, Silicon SPDT, Reflective Switch, 0.7 GHz to 4.0 GHz

Analog Comparators 4.5ns Single High Speed Comparator

Analog Devices LTC6363HMS8-0.5#PBF is a integrated circuit for embedded electronics, industrial controls, instrumentation, and production BOM sourcing. It offers 8 pins, -40°C to 125°C in Small Outline Packages. From quote-based sourcing, buyers can request stock checks and worldwide shipping support.

ANALOG DEVICES - AD8643ACPZ-REEL7 - Operational Amplifier, Quad, 4 Amplifier, 2.5 MHz, 2 V/µs, ± 2.5V to ± 13V, 5V to 26V, LFCSP

LTC1407IMSE-1#PBF is a 12-bit, 3 Msps simultaneous-sampling ADC by Analog Devices with ±1.25 V analog input range and 0.66 µs max conversion time. Key specs: dual-channel simultaneous sampling, 10-pin MSOP package, serial SPI-compatible output. Available in stock with worldwide shipping.

LEADLESS, QFN-24

The LT1792AIS8#PBF is a precision low-noise JFET-input operational amplifier from Analog Devices, featuring 80 dB minimum CMRR, 0.008 µA maximum bias current at 25°C, internal frequency compensation, and voltage-feedback architecture in an 8-pin SOIC package.

LTC2380IDE-24#PBF is a 24-bit, 2 Msps successive approximation (SAR) ADC with integrated digital filter from Analog Devices, featuring a -2.5 V to 5.1 V analog input range and 0.392 µs conversion time in a 16-pin MSOP package. Ideal for high-resolution industrial and instrumentation data acquisition. In stock from authorized distributors with worldwide shipping.

LTC2324CUKG-16#PBF is a quad-channel 16-bit successive approximation ADC from Analog Devices achieving 2 MSPS per channel with simultaneous sampling across all 4 inputs in a 52-pin QFN package. It delivers better than 0.02% linearity error with a ±2 V input range, ideal for high-speed data acquisition. Available with fast worldwide shipping and competitive pricing.

LT3062EMS8E-5#PBF is a 45 V input, 200 mA low-dropout linear regulator from Analog Devices with 5 V fixed output, 0.3 V typical dropout, and micropower quiescent current with low noise. Features output discharge and is housed in an MSOP-8 package. Available from stock worldwide.

LTC2367CMS-18#PBF is an 18-bit successive approximation ADC from Analog Devices featuring 1.5 µs maximum conversion time, 0.001% linearity error, and up to 5.1 V analog input in a 16-pin MSOP package. It targets precision data acquisition, medical imaging, and industrial instrumentation applications requiring high resolution and fast throughput.

LTC2865HDE#TRPBF is a full-duplex RS-485/RS-422 transceiver with selectable 20 Mbps or 250 kbps data rates, ±60 V fault protection, and a separate logic supply, housed in a 12-pin DFN package. It features differential Schmitt trigger receivers and enable controls for robust industrial communication over long cable runs.

Analog Devices LT1115CSW#TRPBF is a single ultra-low noise voltage-feedback op-amp in a 16-pin SOIC-W package, rated for ±22V supply. It achieves 123 dB typical CMRR and 0.38 µA bias current at 25°C. Available in tape-and-reel with worldwide shipping.

LDO Voltage Regulators 3.3/5Vin 1.2A Ultra Low Noise LDO ADJ

LDO Voltage Regulators CMOS LDO 6.5V 500mA 6.5 V, 500 mA, Ultralow Noise, High PSRR, Fast Transient Response CMOS LDO

High Speed Operational Amplifiers 6mA 70MHz 1000V/uSec Op Amp

LTC6102IMS8-1#PBF is a zero-drift current sense amplifier with shutdown from Analog Devices, featuring 50 µV max input offset voltage and 0.02 µA bias current in an MSOP-8 package. Ideal for precision high-side current measurement. In stock worldwide with global shipping.

Analog Devices ADUM5000WARWZ-RL is an isolated DC/DC converter in a 16-lead SOIC-wide package, providing regulated power across an isolation barrier from a 3 V to 3.6 V input. Delivers 35% efficiency for powering isolated logic and interface circuits. Available in stock with worldwide shipping.

The Analog Devices AD630BD is a precision 2 MHz balanced modulator/demodulator IC in a 20-pin ceramic DIP package, designed for synchronous detection and lock-in amplifier applications. It delivers high carrier suppression and operates from ±15 V supplies for demanding analog signal processing. Available worldwide for instrumentation, communications, and scientific measurement system designs.

The LTC1662IMS8#TRPBF is a dual 10-bit DAC in an 8-pin MSOP package with ultra-low power consumption, operating from a single 2.7 V to 5.5 V supply, ideal for portable and battery-powered applications.

LT3062IMS8E-5#PBF is a 45 V input, 200 mA fixed 5 V output micropower LDO linear regulator with low noise and output discharge in an MSOP-8 package. Available from stock worldwide with fast shipping and competitive pricing.

Analog Devices LTC2865IMSE#PBF is a full-duplex RS-422/RS-485 transceiver with selectable 20 Mbps or 250 kbps data rates and ±60 V fault protection. It integrates a separate logic supply pin and differential Schmitt-trigger inputs in a 12-pin MSOP package. From $5.20 in stock with worldwide shipping.

Analog Devices LT4320HDD#PBF is an ideal diode bridge controller IC that drives 4 external N-channel MOSFETs to form a low-loss full-wave bridge rectifier. Offered in an 8-pin SOIC package with heat sink slug, it supports input voltages from 9 V to 72 V for AC-DC and energy harvesting applications. Available in stock worldwide with competitive pricing.

Operational Amplifiers - Op Amps High Speed Buffer

The LT1672IMS8#PBF is a precision rail-to-rail input/output operational amplifier from Analog Devices with 2 µA supply current, 96 dB minimum CMRR, voltage-feedback architecture, and minimum gain of 5, packaged in an 8-pin MSOP for low-power precision signal conditioning.

Op Amp Dual GP R-R I/O ±8V/16V Automotive 8-Pin MSOP Tube

Analog Devices AD713JN, Op Amp, 4MHz, 14-Pin PDIP

Digital Isolator CMOS 4-CH 150Mbps 16-Pin SOIC W Tube

20 V, 500 mA, Low Noise, CMOS LDO

The LT3652IMSE#TRPBF is an Analog Devices 2 A step-down battery charger IC optimized for solar-panel and wide-input-range power sources, supporting Li-Ion, Li-Polymer, and SLA chemistries. It features input voltage regulation for maximum power point tracking and programmable charge current up to 2 A. Housed in a 12-lead MSOP package for compact solar energy-harvesting and portable power applications.

LT3062EMS8E-3.3 is a micropower 200 mA LDO voltage regulator from Analog Devices with a wide 3.9 V to 45 V input range and ultra-low noise output. It features an integrated output discharge function and 300 mV typical dropout voltage at a fixed 3.3 V output. Available in an 8-pin MSOP package with worldwide shipping.

AD7768-1BCPZ is a precision 24-bit delta-sigma ADC from Analog Devices supporting DC to 204 kHz dynamic signal analysis with power scaling, housed in a 28-pin QFN package. It features 0.0007% maximum linearity error, 2 V to 5.5 V analog input range, and flexible power modes. Available in stock with worldwide shipping.

Analog Devices LT6004CMS8#TRPBF is a dual precision rail-to-rail input and output op-amp operating from a 1.6 V supply with 825 µV maximum input offset voltage and 100 dB typical CMRR. It is housed in an 8-pin MSOP package suitable for low-voltage, low-power sensor signal conditioning. Available from authorized distributors with worldwide shipping.

LT6700HVHS6-2 is a micropower dual comparator with an integrated 400 mV precision reference from Analog Devices, featuring open-collector outputs and just 0.01 µA input bias current at 25°C. It operates from 1.4 V to 18 V and is housed in a tiny SOT-23 6-pin package, suited for battery-powered window comparators, threshold detectors, and level monitors.