Analog Devices

Analog Devices LTC1518CS#TRPBF is a quad RS-485/RS-422 line receiver in 16-SOIC with differential Schmitt trigger inputs. It supports EIA-422 and EIA-485 interface standards with 4 independent receiver channels. Available in stock with worldwide shipping.

LTC6362IMS8#PBF Analog Devices, Differential Amplifier 180MHz Rail to Rail Input/Output 8-Pin MSOP

Hot Swap Voltage Controllers ON Pin + Auto-Retry IC.

LTC3113EDHD#TRPBF is a high-efficiency DC-DC buck-boost converter from Analog Devices, operating from 1.8V to 5.5V input and delivering up to 3A output current. It supports non-inverting, inverting, step-up, and step-down topologies in a compact 16-pin DFN EP package, ideal for battery-powered applications.

Analog Devices LTC3630AMPMSE#PBF is a high-efficiency 76 V input, 500 mA synchronous step-down DC-DC converter with adjustable output from 0.8 V to 76 V, plus fixed 3.3 V and 5 V preset modes. Uses voltage-mode PWM control in a compact MSOP package. Available from stock worldwide.

Analog Devices LT6703IDC-2#TRMPBF is a single automotive-grade voltage comparator rated to 18 V with open-collector output and a maximum input bias current of 0.01 µA in an ultra-compact 3-pin DFN-EP package. It suits space-constrained automotive and industrial threshold detection circuits. Available worldwide with global distribution.

Analog Devices LTC3108IGN#PBF is an ultralow input voltage step-up converter and power manager operating from 20 mV to 500 mV input, with selectable regulated outputs of 2.35 V, 3.3 V, 4.1 V, or 5 V in a 16-pin SSOP package. Ideal for energy harvesting from thermoelectric generators and other millivolt sources. Available from stock with worldwide shipping.

Hot Swap Controller 1 Channel General Purpose 8-SOIC

Analog Devices LTC4361IDC-2#TRMPBF is a single-channel overvoltage and overcurrent protection controller with automatic retry, packaged in a compact 8-pin DFN (SOT-23 compatible no-lead) package. It monitors input rails for fault conditions and disconnects the load within microseconds, then automatically retries after a fixed timeout period. Available from authorized distributors with worldwide shipping.

Analog Devices LTC4368IDD-1#PBF is a 100V overvoltage, undervoltage, overcurrent, and reverse supply protection controller with a -50mV reverse threshold. Adjustable thresholds and single-channel operation in a DFN-10 package protect sensitive downstream loads in industrial and telecom power systems.

Digital to Analog Converters - DAC 1 Channel, 16-Bit +/-4-to-20 mA and Vout

Analog Devices LTC6930IMS8-8.19#PBF is a silicon oscillator providing 8.192 MHz base frequency with binary-divided outputs down to 64 kHz, CMOS output, 3 ns fall time, and 5 pF output load in an MSOP-8 package. Available from stock with worldwide shipping.

Analog Devices LT1990IS8-10#PBF is a precision differential amplifier with fixed gain of 10, 100 MHz bandwidth, 72 dB typical CMRR, and 4.5 mV max input offset voltage in an SOIC-8 package. Available from stock with worldwide shipping.

The LTC6930HMS8-8.19#PBF is a precision micro-power CMOS oscillator operating at 8.192 MHz with a 3 ns maximum fall time and 5 pF output load capability. It covers a frequency range from 32.76 kHz to 8.192 MHz and features surface-mount packaging in an MSOP-8 footprint for compact timing applications. Available from stock with worldwide shipping.

Analog Devices LT1990 precision difference amplifier in 8-pin SOIC package, rated for ±250V common-mode input voltages. Delivers 7.4 µV maximum input offset voltage and 68 dB typical CMRR for high-voltage differential signal measurement. Available in lead-free version with worldwide distribution for industrial and test applications.

The LTC6655CHMS8-5#TRPBF is an ultra-low noise 5V precision voltage reference from Analog Devices, offering output voltage of 5.0000V with ±0.025% accuracy and low noise performance. Available in MSOP-8 package with worldwide shipping.

Analog Devices LT6016 dual rail-to-rail input/output precision op-amp in 8-pin MSOP package, automotive grade. Operates on supply voltages up to ±15V or 30V single supply with 110 dB minimum CMRR. Available on tape and reel in lead-free version for high-volume automotive and industrial designs.

Analog Devices LT6016IMS8#TRPBF is a dual rail-to-rail input/output op-amp rated for ±15 V or 30 V supply in automotive-grade MSOP-8. It achieves 126 dB typical CMRR and 5 nA bias current at 25°C. Available in stock with worldwide shipping.

LT6016HMS8#TRPBF is a dual general-purpose rail-to-rail input/output operational amplifier from Analog Devices, operating from ±15V or 30V single supply. It offers 110 dB CMRR, 15 µV offset voltage, and meets AEC-Q100 automotive qualification for harsh-environment designs.

Switching Voltage Regulators 2A 700KHz NonSync Step-Down

The LTC4162EUFD-L41#PBF is a multi-cell lithium-ion step-down battery charger with PowerPath control and I2C telemetry, supporting up to 35V input and 3.2A charge current. It features precise 4.1V/cell charging, input current limiting, and real-time monitoring via I2C. Available in a 28-pin QFN package with worldwide shipping.

Data Acquisition ADCs/DACs - Specialized Energy Meter IC w/Int Oscillator

40 V, 200 mA, Low Noise, CMOS LDO Linear Regulator

LDO Voltage Regulators 600mA Ultra-Low-Nois High-PSRR LDO ADJ

Analog Devices ADAU1701 is a complete SigmaDSP audio processor integrating 2 ADC inputs, 4 DAC outputs, and a powerful 28/56-bit audio DSP core in a single chip. Available in stock worldwide with competitive pricing.

The LTC6253IMS8#TRPBF is a power-efficient 800 MHz rail-to-rail input/output op-amp with 3.5 mA supply current, 105 dB typical CMRR, and ultra-low 0.7 µA average bias current for high-speed signal processing applications. It uses voltage-feedback architecture with full rail-to-rail I/O swing, maximizing dynamic range in single-supply designs. Available from stock with worldwide shipping.

SOIC-16

Voltage References LOW NOISE, MICROPWR PRECISION VOLT. REF.

LT1021DCN8-5#PBF is a precision 5 V three-terminal voltage reference in an 8-pin DIP package, with 20 ppm/°C maximum temperature coefficient and 10 mA output current capability. Available from stock with worldwide shipping.

Analog Devices LT3081ER#TRPBF is a rugged 1.5A adjustable LDO linear regulator with single-resistor output programming and 1.23V dropout in a 7-pin MSOP-like package. It supports parallel operation for high-current applications and withstands reverse current, reverse input voltage, and reverse output voltage for robust industrial and communications power rails.

Analog to Digital Converters - ADC Quad, 16-Bit, 400ksps Differential ±5V Input SoftSpan ADC with Wide Input Common Mode Range

LDO Voltage Regulators 600mA Ultra-Low-Nois High-PSRR LDO ADJ

LDO Voltage Regulators 600mA Ultra-Low-Nois High-PSRR LDO ADJ

Clock Synthesizer / Jitter Cleaner

Analog Devices LTC6655CHMS8-5#PBF is an ultra-low-noise 5 V precision voltage reference in an MSOP-8 package. Delivers 4.9975 V to 5.0025 V output with extremely low noise and tight initial accuracy. Available from stock with worldwide shipping.

Analog Devices LTC1064-2 switched-capacitor low-pass filter with 140 kHz maximum cutoff frequency in 16-pin SOIC package. Supports single or dual supply operation up to ±7.5V with 8th-order Butterworth response. Available from stock with worldwide shipping.

► isoPower integrated, isolated dc-to-dc converter ► 100 mA output current for ADuM6020 ► 60 mA output current for ADuM6028 ► AEC-Q100 qualified for automotive applications ► Meets CISPR22 Class B emissions limits at full load on a 2‑layer PCB

LC2MOS 16-Bit Voltage Output DAC

LDO Voltage Regulators 800mA ULN LDO 5.0Vo

Voltage References 4.096V CMOS 8ppm/C Voltage REF

The LT5400BCMS8E-4#PBF is a precision dual matched resistor network from Analog Devices featuring two 1 kΩ elements with ultra-low tracking error and 0.8 W dissipation rating. Its isolated network topology ensures high common-mode rejection for differential signal paths. Surface-mount MSOP-8 package available in stock worldwide.

Analog Devices LTC6102HMS8-1#PBF is a precision current sense amplifier with 200 kHz bandwidth, 50 µV max input offset voltage, and 20 nA max bias current in an MSOP-8 package. Available from stock with worldwide shipping.

LTC2956IMS-1#PBF is a pushbutton power controller and wake-up timer IC from Analog Devices featuring programmable hold times, debounced pushbutton input, interrupt output, and supervisor functions in a 12-pin TSSOP. Handles power-on sequencing and orderly shutdown for portable systems. Available worldwide with fast shipping.

Data Acquisition ADCs/DACs - Specialized 1 PH Mtr IC w/Auto Calibration

Analog Devices LT6105HMS8#PBF is a precision high-side current sense amplifier with -0.3V to 44V common-mode range, 120 dB typical CMRR, and 0.8 µV maximum input offset voltage in an 8-pin SOIC package. In stock worldwide.

Accelerometer Triple ±0.5g/±1g/±2g/±4g 3.3V Automotive 32-Pin LFCSP EP T/R

The LTC4057ES5-4.2#TRPBF is a standalone linear Li-Ion battery charger IC with a 4.2V charge termination voltage and programmable charge current up to 600mA, designed for single-cell lithium-ion and lithium-polymer batteries. It features an adjustable charge current threshold and a thermistor input for temperature-qualified charging, all in a compact 5-pin TSOT-23 package. Available in tape-and-reel from Analog Devices with worldwide shipping.

The LT6654AHS6-1.25#TRMPBF is a precision 1.25V three-terminal voltage reference with ±0.2% initial accuracy, 100mA output current capability, and low temperature drift, designed for high-accuracy ADC and DAC reference applications. It operates from input voltages up to 12.6V and is housed in a compact 6-pin SOT-23 package for space-constrained designs. Available from Analog Devices in tape-and-reel with worldwide shipping.

The LTC6409HUDB#TRMPBF is a high-speed differential amplifier with 10 GHz gain-bandwidth product and ultra-low noise of 1.1 nV/√Hz, ideal for wideband signal processing. It offers 85 dB common-mode rejection ratio and supports supply voltages from 3.3 V to 5 V. Available from stock with worldwide shipping.

LTC2953CDD-2#PBF is a pushbutton on/off controller integrating dual-input battery monitoring, output supervision, and interrupt generation for system power management. Features adjustable thresholds in a 12-pin DFN package. Available from stock worldwide at competitive pricing.