Analog Devices

The MAX147BEAP+T is an 8-channel, 12-bit successive approximation ADC operating from a 2.7 V to 5.25 V supply with a maximum conversion time of 65 µs. It communicates via a 3-wire SPI-compatible serial interface in a 20-pin SSOP package.

Translation - Voltage Levels MAX13058EETI+

Battery Battery Protection IC 15-WLP (1.57x2.14)

The MAX14509AEEVB+ is an Analog Devices evaluation board for the MAX14509AE USB 2.0 Hi-Speed audio DPDT analog switch IC featuring 2-channel switching, 65 dB off-state isolation, and 0.2 Ω on-resistance match. Enables rapid prototyping of USB and audio switching designs. Available in stock with worldwide shipping.

Analog Devices MAX13041ASD+T is a single-channel CAN bus transceiver IC supporting data rates up to 1000 Mbps, operating from -40°C to +125°C, housed in a 14-pin SOIC package. Designed for robust high-speed serial communication in automotive and industrial environments.

Dual Nonvolatile Digital Potentiometer and Secure Memory

Analog Devices DG508AAK/883B is an analog switch for electronic assemblies. It is specified around 16 pins for matching footprints and electrical requirements. From inquiry pricing with worldwide shipping support.

Supervisory Circuits 3.3/5V MicroMonitor

Temperature Sensor Analog, Local -50°C ~ 150°C 22.5mV/°C TO-92-3

Ethernet ICs 10/100 Base Tx Transcvr w/MDIX-IND

MAX811TEUS+T is a microprocessor supervisor with manual reset and active-low reset output by Analog Devices, operating from 1.2 V to 5.5 V input in a 4-pin SOT-23 package. It monitors supply voltage and asserts a clean reset pulse for microcontrollers and processors in industrial, consumer, and portable electronic designs.

300 MHz TigerSHARC Processor with 6 Mbit on-chip SRAM

Board Mount Temperature Sensors 1-Wire Parasite-Power Digital Thermometer

Triple Transmitter Quint Receiver RS-232 28-Pin TSSOP T/R

The MAX6315US29D3+T is a microprocessor supervisor IC with a 2.93 V reset threshold, 336 ms reset timeout delay, active-low open-drain output, and supports 1 V to 5.5 V supply voltage in a 4-pin SOT-23 package for reliable system reset control.

Analog Devices HMC839LP6CE is a high-performance PLL with integrated VCO operating from 1930 to 2380 MHz, housed in a 40-lead QFN package for compact RF module designs. It combines phase-locked loop and voltage-controlled oscillator functions for low-phase-noise signal synthesis.

1.5A Low Dropout Positive Regulators Adjustable and Fixed 2.85V, 3.3V, 3.6V, 5V, 12V

Voltage Comparator, Single, 8 Pin, Plastic, SOP

Series Voltage Reference IC Fixed 10V V ±0.3% 10 mA TO-5-3

Analog Switch ICs 2.5ohm Max Ron +/-15V/+12V/+5V iCMOS SPST

The MAX20303LEWN+T is an integrated PMIC from Analog Devices with ultra-low IQ voltage regulators, a Li-ion battery charger, and a fuel gauge in a 56-ball WLCSP package. It provides 8 power management channels for compact wearable and IoT systems powered by small lithium-ion cells.

USB Switch ICs USB Host Adapter Emulator with Advanced CDP Emulation

The MAX14654EWC+T is a high-current overvoltage protector IC from Analog Devices with an adjustable overvoltage lockout (OVLO) threshold, designed to protect sensitive downstream circuits in a 12-bump WLCSP package. It monitors input voltage and disconnects the load when an overvoltage event is detected. Available in stock with worldwide shipping.

MAX3645ESE+T is a Analog Devices operational amplifier IC for signal conditioning and data acquisition. It combines 16 pins, Small Outline Packages, 2.97V for reliable board-level integration. Quote-based sourcing supports stock checks and worldwide shipping.

Switching Voltage Regulators For MAX17630A: 4.5V to 36V, 1A, High-Efficiency, Synchronous Step-Down DC-DC Converter with 3.3V Output Voltage; For MAX17630B: 4.5V to 36V, 1A, High-Efficiency, Synchronous Step-Down DC-DC Converter with 5V Output Voltage; For MAX17631A: 4.5V to 36V

RS-422/RS-485 Interface IC +5.0V, +/-15kV ESD-Protected, Fail-Safe, Hot-Swap, RS-485/RS-422Transceivers

Switching Voltage Regulators 60V Synchronous Step-down Regulator with Integrated Dual 5V, 1A POL

The MAX22701EASA+T is an ultra-high CMTI isolated gate driver optimized for Silicon Carbide (SiC) MOSFETs and IGBTs. It provides strong peak gate drive current with high common-mode transient immunity to reliably switch wide-bandgap devices at high dV/dt rates. Packaged in an 8-SOIC for industrial inverter and EV power conversion designs.

VCO Oscillators VCO w/ Fo/2 & Div/4, 11.5 - 12.5 GHz

Clock Buffer Ultralow Jitter, 7.5GHz, 11 Output Fanout Buffer Family

General Purpose Amplifiers SO-14 RoHS

Power Management Specialised - PMIC Power Supply On/Off Sequencer

Quad-Channel Isolators with Integrated DC-to-DC Converter (2:2 directionality)

50ppm/°C (max) Temperature Coefficient Guaranteed over the -40°C to +125°C Temperature RangeUltra-Small 3-Pin SC70 Package0.1% (max) Initial AccuracyWide Operating Current Range: 60µA to 15mALow 28µVRMS Output Noise (10Hz to 10kHz)1.225V, 2.048V, 2.500V, 3.000V, 3.3V, 4.096V, and 5.000V Fixed Reverse Breakdown VoltagesNo Output Capacitors RequiredTolerates Capacitive LoadsAEC-Q100 Qualified, Refer to Ordering Information for the Specific /V Versions

Micropower, 3-Axis, ±200 g Digital Output, MEMS

Power Management Specialised - PMIC Wearable Power Management Solution with Low Iq Display

16-Bit, 4-Channel/8-Channel, 250 kSPS PulSAR ADCs, 20-lead 2.4 mm × 2.4 mm WLCSP package

LT1004CZ-1.2#PBF is a two-terminal shunt voltage reference IC with a fixed 1.235 V output and ±0.3% initial accuracy, supporting up to 20 mA operating current. It comes in a TO-92-3 through-hole package and is well-suited for precision analog circuits requiring a stable low-voltage reference with minimal external components.

100V Flyback Regulator Positive, Isolation Capable Output Step-Up/Step-Down DC-DC Controller IC 16-MSOP

IC SWITCH TRIPLE SPDT 16TSSOP

LTC3876IUHF#PBF is a dual-output DDR voltage regulator controller from Analog Devices using current-mode controlled on-time architecture. Key specs: 4.5 V to 38 V input range, adjustable outputs from 1 V to 2.5 V, and dual-channel operation in a 38-pin QFN (5x7) package. Available in stock with worldwide shipping.

Digital Signal Processors & Controllers - DSP, DSC 400 MHz SHARC in an LQFP package

400MHz SHARC+ DSP with 640KB L1, 256KB Shared L2 SRAM, 120-lead LQFP_EP

Interface - I/O Expanders I C Port Expander with 4 Push-Pull Outputs and 4 Inputs

The MAX1127EGK+D is a quad 12-bit analog-to-digital converter sampling at up to 65 MSPS from a 1.8 V supply in a compact 68-pin LFCSP package. It offers four simultaneous ADC channels with excellent linearity for demanding RF, communications, and instrumentation applications.

LTC4091EDJC#TRPBF is a 36 V linear battery charger and power backup manager IC from Analog Devices, designed for single-channel Li-ion or Li-polymer backup battery systems. It features adjustable charge thresholds, integrates charger and power path management in a 22-pin DFN package, and suits industrial and telecom equipment requiring battery backup up to 36 V.

DS28C39Q+U is a Analog Devices integrated circuit for industrial electronics and embedded systems. It combines 7 pins, Small Outline No-lead for reliable board-level integration. Quote-based sourcing supports stock checks and worldwide shipping.

Analog Comparators Dual nanoPower Comparator with Built-In Reference

Digital to Analog Converters - DAC 16-Bit Dual SoftSpan Iout DAC with Parallel I/O (1LSB INL)

LTC1059CS is a switched-capacitor universal active filter IC with a tunable cutoff frequency from 0.1 kHz to 40 kHz in a 14-pin SOIC package. It supports lowpass, highpass, bandpass, and notch configurations with clock-tunable response, making it ideal for anti-aliasing, data acquisition, and audio signal conditioning designs.