Analog Devices

Analog Devices MAX1295 is a 12-bit successive-approximation ADC with up to 6 analog input channels, 265 ksps throughput, and an integrated 2.5 V reference operating from a single 3 V supply. Features a parallel interface for fast data transfer. Ideal for multi-channel data acquisition and industrial measurement systems.

Switching Voltage Regulators 36V, 2.2MHz Step-Down Converter with Low Operating Current

The MAX1556AETB+ is a current-mode PWM step-down DC-DC converter from Analog Devices with an input range of 2.6 V to 5.5 V and adjustable output from 0.75 V to 5.5 V or fixed 2.5 V and 3.3 V operation. It is housed in a compact 10-pin 3x3 mm LFCSP package for space-constrained portable and battery-powered applications.

MAX15027ATB+ is a BiCMOS adjustable LDO linear regulator from Analog Devices with a typical dropout voltage of only 75 mV and a single output in a compact 10-pin LFCSP (3x3x0.75 mm) package. Designed for low-noise, high-efficiency power rails in space-constrained portable and industrial electronics.

Analog Devices MAX15103EWL+ is a 3 A adjustable low-dropout linear regulator in a compact 2.7 mm x 1.6 mm 15-ball WLCSP package with 65 mV typical dropout voltage. Offers 0.15% per volt line regulation for stable output in space-constrained power designs. Available from authorized distributors with worldwide shipping.

The MAX16003ETE+T is a 6-channel voltage supervisor and reset IC with adjustable thresholds, open-drain outputs, and a manual reset input. It monitors up to 6 independent voltage rails and asserts reset signals when any rail drops below its threshold. Housed in a compact 16-TQFN (4x4 mm) package for dense multi-rail power management.

MAX15021ATI/V+ is a Analog Devices integrated circuit for industrial electronics and embedded systems. It combines 28 pins, 28-LFCSP-5X5X0.75, -40°C to 125°C for reliable board-level integration. Quote-based sourcing supports stock checks and worldwide shipping.

Analog Devices MAX15096GWE+ is a single-channel input fault protection controller in a compact 16-bump WLCSP package with adjustable threshold, designed to protect downstream circuits from overvoltage and overcurrent faults. Available globally with fast shipping and competitive pricing.

MAX13055EETI+ is an 8-channel high-speed logic level translator supporting voltage levels from 1.62 V to 3.6 V per supply rail in a compact 28-pin LFCSP package. It enables bidirectional signal translation between different logic domains in mixed-voltage SoC and FPGA designs.

Analog Devices MAX149BMAP/PR3+T is a low-power 10-bit successive-approximation ADC with 8 analog input channels and a serial interface, operating from 2.7 V to 5.25 V with a maximum conversion time of 65 µs, housed in a 20-pin SSOP package. It is designed for portable data-acquisition instruments, battery-powered sensor hubs, and multichannel industrial monitoring applications.

The MAX15059BATE+ is a current-mode PWM switching regulator operating from a 2.8 V to 5.5 V input, with an adjustable mode extending operation from 7.8 V to 76 V for flexible boost or SEPIC topologies. Housed in a compact 16-pin 3x3 mm LFCSP QFN package, it delivers efficient DC-DC conversion for portable, industrial, and LED driver designs.

Maxim DS28EC20P+, 20kbit EEPROM Memory 64-Pin TSOC Serial-1 Wire

The MAX147BEAP+T is an 8-channel, 12-bit successive approximation ADC operating from a 2.7 V to 5.25 V supply with a maximum conversion time of 65 µs. It communicates via a 3-wire SPI-compatible serial interface in a 20-pin SSOP package.

Translation - Voltage Levels MAX13058EETI+

Battery Battery Protection IC 15-WLP (1.57x2.14)

The MAX14509AEEVB+ is an Analog Devices evaluation board for the MAX14509AE USB 2.0 Hi-Speed audio DPDT analog switch IC featuring 2-channel switching, 65 dB off-state isolation, and 0.2 Ω on-resistance match. Enables rapid prototyping of USB and audio switching designs. Available in stock with worldwide shipping.

Analog Devices MAX13041ASD+T is a single-channel CAN bus transceiver IC supporting data rates up to 1000 Mbps, operating from -40°C to +125°C, housed in a 14-pin SOIC package. Designed for robust high-speed serial communication in automotive and industrial environments.

Dual Nonvolatile Digital Potentiometer and Secure Memory

Supervisory Circuits 3.3/5V MicroMonitor

Temperature Sensor Analog, Local -50°C ~ 150°C 22.5mV/°C TO-92-3

Ethernet ICs 10/100 Base Tx Transcvr w/MDIX-IND

MAX811TEUS+T is a microprocessor supervisor with manual reset and active-low reset output by Analog Devices, operating from 1.2 V to 5.5 V input in a 4-pin SOT-23 package. It monitors supply voltage and asserts a clean reset pulse for microcontrollers and processors in industrial, consumer, and portable electronic designs.

300 MHz TigerSHARC Processor with 6 Mbit on-chip SRAM

Board Mount Temperature Sensors 1-Wire Parasite-Power Digital Thermometer

Triple Transmitter Quint Receiver RS-232 28-Pin TSSOP T/R

The MAX6315US29D3+T is a microprocessor supervisor IC with a 2.93 V reset threshold, 336 ms reset timeout delay, active-low open-drain output, and supports 1 V to 5.5 V supply voltage in a 4-pin SOT-23 package for reliable system reset control.

Analog Devices HMC839LP6CE is a high-performance PLL with integrated VCO operating from 1930 to 2380 MHz, housed in a 40-lead QFN package for compact RF module designs. It combines phase-locked loop and voltage-controlled oscillator functions for low-phase-noise signal synthesis.

1.5A Low Dropout Positive Regulators Adjustable and Fixed 2.85V, 3.3V, 3.6V, 5V, 12V

Voltage Comparator, Single, 8 Pin, Plastic, SOP

Series Voltage Reference IC Fixed 10V V ±0.3% 10 mA TO-5-3

Analog Switch ICs 2.5ohm Max Ron +/-15V/+12V/+5V iCMOS SPST

The MAX20303LEWN+T is an integrated PMIC from Analog Devices with ultra-low IQ voltage regulators, a Li-ion battery charger, and a fuel gauge in a 56-ball WLCSP package. It provides 8 power management channels for compact wearable and IoT systems powered by small lithium-ion cells.

USB Switch ICs USB Host Adapter Emulator with Advanced CDP Emulation

The MAX14654EWC+T is a high-current overvoltage protector IC from Analog Devices with an adjustable overvoltage lockout (OVLO) threshold, designed to protect sensitive downstream circuits in a 12-bump WLCSP package. It monitors input voltage and disconnects the load when an overvoltage event is detected. Available in stock with worldwide shipping.

MAX3645ESE+T is a Analog Devices operational amplifier IC for signal conditioning and data acquisition. It combines 16 pins, Small Outline Packages, 2.97V for reliable board-level integration. Quote-based sourcing supports stock checks and worldwide shipping.

Switching Voltage Regulators For MAX17630A: 4.5V to 36V, 1A, High-Efficiency, Synchronous Step-Down DC-DC Converter with 3.3V Output Voltage; For MAX17630B: 4.5V to 36V, 1A, High-Efficiency, Synchronous Step-Down DC-DC Converter with 5V Output Voltage; For MAX17631A: 4.5V to 36V

RS-422/RS-485 Interface IC +5.0V, +/-15kV ESD-Protected, Fail-Safe, Hot-Swap, RS-485/RS-422Transceivers

Switching Voltage Regulators 60V Synchronous Step-down Regulator with Integrated Dual 5V, 1A POL

The MAX22701EASA+T is an ultra-high CMTI isolated gate driver optimized for Silicon Carbide (SiC) MOSFETs and IGBTs. It provides strong peak gate drive current with high common-mode transient immunity to reliably switch wide-bandgap devices at high dV/dt rates. Packaged in an 8-SOIC for industrial inverter and EV power conversion designs.

VCO Oscillators VCO w/ Fo/2 & Div/4, 11.5 - 12.5 GHz

Clock Buffer Ultralow Jitter, 7.5GHz, 11 Output Fanout Buffer Family

General Purpose Amplifiers SO-14 RoHS

Power Management Specialised - PMIC Power Supply On/Off Sequencer

Quad-Channel Isolators with Integrated DC-to-DC Converter (2:2 directionality)

50ppm/°C (max) Temperature Coefficient Guaranteed over the -40°C to +125°C Temperature RangeUltra-Small 3-Pin SC70 Package0.1% (max) Initial AccuracyWide Operating Current Range: 60µA to 15mALow 28µVRMS Output Noise (10Hz to 10kHz)1.225V, 2.048V, 2.500V, 3.000V, 3.3V, 4.096V, and 5.000V Fixed Reverse Breakdown VoltagesNo Output Capacitors RequiredTolerates Capacitive LoadsAEC-Q100 Qualified, Refer to Ordering Information for the Specific /V Versions

Micropower, 3-Axis, ±200 g Digital Output, MEMS

Power Management Specialised - PMIC Wearable Power Management Solution with Low Iq Display

16-Bit, 4-Channel/8-Channel, 250 kSPS PulSAR ADCs, 20-lead 2.4 mm × 2.4 mm WLCSP package

LT1004CZ-1.2#PBF is a two-terminal shunt voltage reference IC with a fixed 1.235 V output and ±0.3% initial accuracy, supporting up to 20 mA operating current. It comes in a TO-92-3 through-hole package and is well-suited for precision analog circuits requiring a stable low-voltage reference with minimal external components.

100V Flyback Regulator Positive, Isolation Capable Output Step-Up/Step-Down DC-DC Controller IC 16-MSOP