Analog Devices

Infrared Receivers 4Mbps Infrared Receiver

Accelerometer Single ±500g 5V 4mV/g 32-Pin LFCSP EP T/R

Operational Amplifiers - Op Amps Single 2 A Zero-Drift Operational Amplifier

Active Filters 1.4nV/Rt.Hz 180MHz Filt Building Block

Reliable low cost voltage monitor with reset output Suitable for monitoring 2.5 V, 3 V, 3.3 V, and 5 V power supply voltages Reset threshold levels: 4.62 V, 4.35 V, 3.06 V, 2.88 V, 2.55 V, 2.31 V, and 2.18 V typical Active high and low push-pull output choices: ADM1810, ADM1812, ADM1815, and ADM1817 Open-drain with internal pull-up resistor output choices: ADM1811, ADM1813, ADM1816, and ADM1818 Can be used with a manual push-button to generate a reset: ADM1813, ADM1818 Initialization of microproc

Precision Amplifiers Quad Precision 18MHz Low noise CMOS Op Amp

Digital to Analog Converters - DAC Dual 12-bit Parallel IOUT IC

Current Sense Amplifiers Current Sense Amplifier

Switching Voltage Regulators uPMU V+/V- sw reg for bipolarADC/DAC/AMP

Analog Devices ADUCM360 is a precision analog microcontroller integrating dual 24-bit sigma-delta ADCs with an ARM Cortex-M3 processor in a QFN package. Designed for low-power precision measurement with on-chip PGA, excitation current sources, and 128 KB flash. Available from global distributors with worldwide shipping.

Analog Switch Dual SPDT 16-Pin TSSOP T/R

Analog to Digital Converters - ADC 12-bit, 2-ch 14ksps I2C SAR ADC

Digital Potentiometer ICs 1024 tap, 1% digiPOT with SPI interface

Phase Locked Loops - PLL PLL + VCO 1610-2080MHz /2 x2

Precision Amplifiers Dual uP 1MHz R-to-R Op Amp

LDO Voltage Regulators CMOS LDO 6.5V 1A

LDO Voltage Regulators 1A Hi PSRR FT L DO 1.8Vo

LDO Voltage Regulators 1A Hi PSRR FT L DO 2.5Vo

LTC1560-1IS8 is a continuous-time, low-noise elliptic lowpass filter IC from Analog Devices with selectable 1 MHz or 500 kHz cutoff frequency in an SO-8 package. Key specs include ±5 V supply operation, pin-selectable cutoff, and deep stopband attenuation for anti-aliasing in high-speed data acquisition systems. Available from stock with worldwide shipping.

VCO Oscillators VCO SMT with Fo/2, 9.05 - 10.15 GHz

Precision Amplifiers Dual uP 1MHz R-to-R Op Amp

SMT, 6 PIN

Infrared Receivers 4Mbps Infrared Receiver

IRDA TX/RX 4Mbps 5V 8-Pin SOIC N Tube

Analog Devices LTC2328CMS-18#PBF is an 18-bit, 1 Msps successive approximation ADC with true bipolar ±10 V input range and SPI serial interface in MSOP-16 package. Achieves 0.0019% linearity error and 0.527 µs conversion time. Available from stock with worldwide shipping.

Precision Amplifiers Dual uP 1MHz R-to-R Op Amp

Precision Amplifiers Dual Low Noise OA (Av = 1)

Supervisory Circuits RESET GENERATOR I.C.

Analog Devices ADP7142 is a 40V input, 200mA LDO linear regulator with 3.3V fixed output, 420mV maximum dropout, in 6-pin SOT-23 package, covering -40°C to +125°C for industrial and high-voltage analog supply applications.

LTC1992IMS8#PBF Analog Devices, 2-Channel Differential Amplifier 4MHz Rail to Rail Input/Output 8-Pin MSOP

1.5A, Low Noise, Fast Transient Response LDO Regulators

Analog Devices LTC2877HMSE#PBF is a 60 V fault-protected RS-485/RS-422 transceiver supporting PROFIBUS and operating from 3 V or 5 V logic supplies. It features differential Schmitt trigger inputs and a single driver/receiver channel in a small outline package. The device delivers robust industrial communication with ±60 V bus fault protection for harsh environments.

LDO Voltage Regulators 200mA Negative Vout LDO

The LTC2877CDD#PBF is a full-duplex RS-485/RS-422 and PROFIBUS transceiver supporting data rates up to 20 Mbps, housed in a compact 10-pin DFN package. It operates from either a 3.3 V or 5 V supply and integrates a differential Schmitt-trigger receiver. Suited for industrial fieldbus networks, PLC interfaces, and high-speed differential serial communication links.

LTC6930CMS8-5.00#PBF is a precision silicon oscillator from Analog Devices operating at a nominal 5 MHz with selectable output frequencies down to 32.768 kHz, CMOS output, and 5 pF output load. Packaged in an 8-pin MSOP, it suits low-power timing and clocking applications across industrial and consumer designs.

Precision Amplifiers Dual uP 1MHz R-to-R Op Amp

Analog Comparators Nanopower Comp w/ Ref

42V, 2A/3A Peak Synchronous Step-Down Regulator with 2.5µA Quiescent Current

Analog to Digital Converters - ADC 16-bit, 25Msps, 1.8V Low-Power Dual ADC, Serial LVDS Outputs

IC OPAMP ZERO-DRIFT 2 CIRC 10DFN

Active Filters Active RC Quad Universal Filter

The LTC3410ESC6-1.5#TRMPBF is a 300 mA synchronous step-down switching regulator from Analog Devices operating at 2.25 MHz with a fixed 1.5 V output and current-mode control. It accepts 2.5 V to 5.5 V input and fits ultra-compact SOT-23-6 designs for portable and wearable electronics.

Differential Amplifiers Gain of 2 Fully Differential In/Out Amplifier

Analog Switch ICs LatchupProof +12V +36V 1xSPDT

The LTC6910-2CTS8#TRMPBF is a digitally controlled programmable gain amplifier (PGA) from Analog Devices, offering gains from 0 to 64 V/V with a 13 MHz bandwidth and 55 dB minimum CMRR in an 8-pin SOT-23 package. Designed for precision analog signal conditioning in space-constrained portable and industrial applications.

The LTC1992-2HMS8#TRPBF is a fully differential amplifier with fixed gain of 2 from Analog Devices, featuring 60 dB CMRR and 4 mV input offset voltage in an SOIC-8 package. It converts single-ended signals to differential outputs for ADC driving. Available from stock worldwide with competitive pricing.

The LTC2877IMSE#PBF is a 60 V fault-protected RS-485/PROFIBUS transceiver from Analog Devices, supporting EIA-485 and EIA-422 standards with differential Schmitt trigger inputs and a 3 V to 5 V logic supply range. Housed in an MSOP-8 package, it delivers robust industrial bus communication with overvoltage surge protection.

The LT3955EUHE#PBF is a high-efficiency buck-boost LED driver IC from Analog Devices (Linear Technology) switching at 1 MHz, capable of driving up to 12 LED segments in a 36-pin QFN package. It supports wide input voltage ranges with programmable current regulation for consistent LED brightness. Suited for automotive and industrial LED lighting designs requiring stable output despite fluctuating supply voltages.

Surge Suppressors 140V High Efficiency Sw. Surge Stopper

Digital Isolator CMOS 3-CH 150Mbps 16-Pin SOIC W T/R