Analog Devices

MAXIM INTEGRATED PRODUCTS - MAX40203AUK+T - IDEAL DIODE CURRENT SW, -40 TO 125DEG C

Digital Isolators 1 kV Dual Channel Digital Isolator

Analog Multiplxer Dual 4:1 24-Pin LFCSP EP Tray

IC FILTER LOWPASS 8TH 16-SOIC

Operational Amplifiers - Op Amps Single, Dual, Quad, 1.2 uA Max, Single-Supply Op Amps

Instrumentation Amplifiers 3V/5V Single-Supply Rail-Rail

LDO Regulator Neg -1.22V to -20V 0.2A Automotive 5-Pin TSOT-23

Analog Devices LTM8055IY-1#PBF is a high-power buck-boost μModule regulator delivering 8.5 A output from a 5 V to 36 V input with adjustable output from 1.2 V to 36 V in a 121-ball BGA module. Current-mode PWM control ensures fast transient response and stable operation across wide input/output voltage ranges. The integrated module simplifies high-current power supply designs for industrial and communications equipment.

Adjustable Overvoltage and Overcurrent Protectors with High Accuracy

LDO Regulator Pos 1.2V 5A 16-Pin LFCSP EP T/R

LDO Voltage Regulators 45V VIN, 500mA Low Noise, Linear Regulator with Programmable Current Limit and Power Good

MAX3158CAI is a full/half-duplex RS-422/RS-485 transceiver from Analog Devices integrating 1 driver and 1 receiver in a 28-pin SSOP package. It supports multipoint differential data communication at data rates up to 10Mbps with ±15kV ESD protection for robust industrial network designs.

Special Purpose Amplifiers LT1210 - 1.1A, 35MHz Current Feedback Amplifier

Transimpedance Amplifiers High-Speed Trans impedance preamplifier for optical distance measurement receivers

The LTC6930MPMS8-8.19#TRPBF is a precision micropower CMOS oscillator from Analog Devices operating at 8.192 MHz with ultra-low power consumption. It features a 5 pF output load capability in an MSOP-8 surface mount package. Available with worldwide shipping from leading distributors in stock.

Power Switch ICs - Power Distribution Dual battery power path IC; OTP Auto selection, low soft start, low threshold, 100 ms latch off, no

RMS to DC Converter 1.05V 170uA 800kHz 8-Pin MSOP

Dual-Channel, High-Precision, High-Voltage, Current-Sense Amplifier

Dual-Channel, High-Precision, High-Voltage, Current-Sense Amplifier

Analog Devices LT1781ISW#PBF is a low-power RS-232 line transceiver IC in a 16-pin SOIC package. It integrates 2 drivers and 2 receivers with 15 kV ESD protection on RS-232 I/O pins, operating from a single 5 V supply. Designed for space-constrained serial communication interfaces in industrial, embedded, and portable computing equipment.

MAX5980AGTJ+ is a 4-channel power-device controller IC from Analog Devices (Maxim) with 60 V input rating and 400 kHz switching frequency in a compact TQFN-32 package. Designed for multi-channel DC-DC converter control in network and telecom power systems. Supports synchronous rectification and robust power management in high-density designs. Available from stock with worldwide shipping.

MAXIM INTEGRATED PRODUCTS - MAX14713EWL+ - Power Path Selector, 1.6V to 5.5V, WLP-15

Analog Devices LTC1966MPMS8 is a delta-sigma RMS-to-DC converter with 1.05 V maximum input, 170 µA supply current, and 800 kHz bandwidth in an 8-pin MSOP package. It delivers accurate true-RMS measurement of AC signals without precision resistors or trims. Ideal for power meters, multimeters, AC sensor interfaces, and telecommunications equipment requiring high-accuracy RMS conversion of broadband signals.

Analog Devices LT3015IDD-5#PBF is a 1.5 A low-noise negative linear regulator with a fixed -5 V output and precision current limit. It accepts input voltages from -5.5 V to -30 V, features a 0.31 V typical dropout voltage, and is housed in a compact 8-pin DFN package.

Digital Isolators 2.5kVrms 1Mbps 3/1 ChannelDigIsolator

Improved Precision Micropower Shunt Voltage Reference with Multiple Reverse Breakdown Voltages

Switching Voltage Regulators [Tin-Lead SnPb BGA] 36VIN, 8.5A Buck-Boost uModule Regulator

The Analog Devices LTC3642EMS8E-5#TRPBF is an automotive-grade synchronous step-down (buck) DC-DC converter with a wide 4.5V to 45V input range and fixed 5V output at up to 50mA, featuring burst-mode current control for ultra-low quiescent current. Housed in an 8-pin MSOP with exposed pad, it delivers high efficiency across a broad input voltage range. Suitable for automotive always-on power rails, industrial 24V/48V bus-powered microcontroller supplies, and harsh-environment sensor nodes.

Conv DC-DC 4.5V to 45V Synchronous Step Down Single-Out 5V 0.05A Automotive 8-Pin MSOP EP T/R

Supervisory Circuits Single uPower Reset Circuit

LTC3642IMS8E-3.3#PBF is an automotive-grade synchronous buck DC-DC converter accepting 4.5 V to 45 V input and delivering a fixed 3.3 V output at up to 50 mA. It uses current-mode burst-mode control for high efficiency at light loads in an 8-pin MSOP package. In stock with worldwide shipping.

Switching Voltage Regulators [Tin-Lead SnPb BGA] 36Vin, 5A 2-Quadrant CVCC Step-Down uModule Regulator

LDO Regulator Pos 3.8V to 30V 0.7A 8-Pin SOIC N Tube

Analog Devices LTC3124EFE#PBF is a 15 V, 5 A two-phase synchronous step-up DC/DC converter with output disconnect, accepting input voltages from 0.5 V to 5.5 V and delivering regulated output from 2.5 V to 15 V. Current-mode PWM control and dual-phase architecture minimize input and output ripple for demanding portable power applications. Available worldwide in TSSOP-16 package for battery-powered and IoT power management designs.

1A High Voltage, Efficiency Switching Voltage Regulator

LTC6102HMS8-1 is a high-side current sense amplifier from Analog Devices rated for 60 V automotive applications in an 8-pin MSOP package, with 50 µV maximum input offset voltage and 20 nA maximum bias current. It provides precision current monitoring on high-voltage rails. From $4.90, in stock with worldwide shipping.

Voltage References Ultra Low Noise, 1.25V Precision Voltage Reference

Power Switch ICs - POE / LAN IEEE802.3 af High Efficiency Powered Device with dc/dc converter

Analog Devices LT3061EMS8E-3.3#PBF is a 45 V input, 100 mA micropower low-dropout linear regulator with a fixed 3.3 V output and integrated output discharge. It features a typical dropout voltage of just 250 mV and ultra-low quiescent current for noise-sensitive applications. Available from authorized distributors worldwide with in-stock inventory and competitive pricing.

Supervisory Circuits uP Precision Triple Supply Monitor

Analog Devices LTC2368CMS-16#PBF is a 16-bit single-channel SAR ADC achieving 1 Msps throughput rate with a maximum conversion time of 0.527 µs and analog input up to 5.1 V in a 16-pin MSOP package. Its 0.0011% linearity error delivers precision measurement for demanding signal chains. Available in tube packaging from authorized distributors worldwide.

Supervisory Circuits uP Precision Triple Supply Monitor

The LTC4444IMS8E-5#TRPBF is an automotive-grade dual-output high- and low-side MOSFET gate driver from Analog Devices, delivering up to 1.75 A peak drive current per channel with Schmitt-trigger inputs, housed in an 8-pin MSOP package.

Analog Devices LT3845AIFE#TRPBF is a high-voltage synchronous current-mode step-down controller operating from 4 V to 60 V input with adjustable switching frequency and burst mode. It drives external N-channel MOSFETs for efficient DC-DC conversion in demanding power supply designs.

Switching Voltage Regulators High-Efficiency Buck-Boost Regulator

Switching Voltage Regulators 60V, 4A Synchronous Step-Down Regulator with Rail-to-Rail Programmable Output

The LTC4444EMS8E#PBF is an automotive-grade dual-output high- and low-side MOSFET gate driver from Analog Devices, providing up to 3 A peak drive current with Schmitt-trigger inputs, supplied in an 8-pin MSOP EP tube for automotive half-bridge applications.

LT3845AIFE#PBF is a high-voltage synchronous current-mode step-down controller supporting 4 V to 60 V input. Features adjustable operating frequency, burst mode for light-load efficiency, and drives external N-channel MOSFETs. Designed for telecom, industrial, and automotive DC-DC conversion applications.

LTC2876IMS8E#TRPBF is a 60 V fault-protected RS-485/PROFIBUS transceiver from Analog Devices in an 8-pin MSOP package. It supports half-duplex EIA-485 and EIA-422 communication with differential Schmitt-trigger inputs and operates from a 3.3 V or 5 V supply. Suitable for industrial fieldbus networks requiring robust over-voltage protection and high noise immunity.

Analog Devices LTC4444EMS8E-5#PBF is a 1.75 A dual-output high-side and low-side MOSFET gate driver in an 8-pin MSOP with exposed pad, supporting 5 V bootstrap operation and AEC-Q100 automotive qualification for half-bridge and motor drive designs. Available in stock worldwide with fast shipping.