Integrated Circuit

The Microchip 24LC65/SM is a 64 Kbit I2C Smart Serial EEPROM in an 8-pin SOIJ package. It supports up to 100 kHz clock frequency and offers 1,000,000 write/erase cycles with 200-year data retention. Ideal for embedded systems requiring non-volatile storage with simple two-wire serial interface.

8-bit PIC16F microcontroller running up to 32 MHz with 4096 words of Flash, 256 bytes RAM, ADC, and DAC in a 28-pin SPDIP package. Operates from as low as 2.3 V at 16 MHz for battery-friendly embedded designs. Available from stock with worldwide shipping.

PIC16F1704-I/SL is an 8-bit PIC microcontroller from Microchip running up to 32 MHz, featuring 4096 words of Flash program memory, integrated ADC, DAC, and multiple communication peripherals, housed in a compact 14-pin SOIC package ideal for cost-sensitive embedded applications.

The Microchip MCP2025-500E/SN is a LIN bus transceiver with 500 mA integrated voltage regulator in an SOIC-8 package. It provides physical-layer LIN 2.0 bus interfacing with fault protection and diagnostics. Designed for automotive body electronics, lighting control, and seat/mirror actuator nodes requiring a combined transceiver and power supply solution.

Microchip dsPIC33EV256GM104-I/ML is a 16-bit digital signal controller delivering 70 MIPS at 70 MHz with 256 KB Flash in a 44-pin QFN package, integrating a DSP engine, DMA, and ADC for high-performance motor control and power conversion applications.

PWM Boost Regulator, 36V, 5-Pin SOT-23 Microchip MCP1661T-E/OT, Switching Regulator Step Up 200mA, Adjustable, 32 (Max.) V, 575 kHz, 5-Pin SOT-23

The 24LC1026-I/P is a 1 Mbit I2C serial EEPROM from Microchip, operating at 400 kHz with 128-byte page writes, 1 million write cycles endurance, 200-year data retention, and 2.5V to 5.5V supply. Available in 8-pin PDIP package for industrial applications worldwide.

The 24FC1026-I/SN is a 1 Mbit I2C EEPROM from Microchip featuring 1.8V to 5.5V operation, 1 MHz clock speed, and 1,000,000 write/erase cycle endurance. It supports fast-mode I2C up to 1 MHz and stores data for a minimum of 200 years. Available in SOIC-8 package with worldwide shipping.

The MCP4462T-502E/ST is a quad-channel, 8-bit digital potentiometer from Microchip with a 5 kΩ end-to-end resistance per channel and non-volatile memory in a 14-pin TSSOP package. It uses a 2-wire I2C serial interface and provides 4 independent wiper channels for simultaneous gain or offset control in a single IC. Ideal for multi-channel audio, sensor calibration, and programmable power supply designs requiring persistent wiper settings.

0.300 INCH, LEAD FREE, PLASTIC, SDIP-28

PIC18F24K50-I/SP is an 8-bit PIC18F microcontroller from Microchip with 48 MHz maximum clock, 16 kB Flash memory, integrated ADC and DAC, in a 28-pin SPDIP package. It operates from as low as 2.3 V at 20 MHz, suiting battery-powered USB applications with its built-in USB engine. Available worldwide with factory lead time of approximately 6 weeks.

Microchip PIC18F2320-I/SP is an 8-bit PIC18 Flash microcontroller running at up to 40 MHz with 8 KB of reprogrammable Flash and an integrated 10-bit ADC. It operates from 2 V at 4 MHz for low-power modes up to 5.5 V at full speed. The 28-pin SPDIP package enables through-hole prototyping and ease of socketing.

DIP-40

Digital Signal Processors & Controllers - DSP, DSC 16 Bit 5V DSC 256KB ECC Flash, 16KB RAM

Microchip PIC16F57-I/SP is an 8-bit PIC microcontroller with 2048x12-word Flash memory running up to 20 MHz. It operates from a 2V minimum supply at 4 MHz and comes in a 28-pin SPDIP through-hole package. Suitable for cost-sensitive embedded control and prototyping applications worldwide.

MCU PIC32 128KB 32-Bit Flash 100Pin TQFP Microchip PIC32MX530F128L-I/PT, 32bit M4K, MIPS32 Microcontroller, 40MHz, 128 kB Flash, 100-Pin TQFP

Microchip PIC24FJ64GA002-I/SP is a 16-bit microcontroller with 64 KB Flash and 8 KB RAM running at up to 32 MHz. It integrates a 10-bit ADC, UART, SPI, I2C, and USB OTG peripherals in a 28-pin SPDIP through-hole package. Well suited for mid-range embedded control and data acquisition designs.

Microchip PIC24FJ64GB002-I/SP is a 16-bit PIC24 microcontroller with 64KB Flash, 8KB RAM, integrated USB, and ADC running at up to 32 MHz, housed in a 28-pin SPDIP through-hole package. It supports boundary scan debugging and is suited for USB-enabled embedded control applications requiring a breadboard-friendly DIP form factor.

Microchip MCP1825S-3302E/AB is a fixed 3.3 V LDO linear regulator delivering up to 500 mA output current with only 0.35 V maximum dropout voltage and 6 V maximum input, housed in a TO-220-3 package for low-noise power supply designs.

The Microchip MCP8026-115E/PT is a 3-phase brushless DC motor controller IC integrating gate drivers for six external power MOSFETs and a peak output drive current of 0.5 A. It provides hall-sensor commutation, overcurrent protection, and fault reporting in a 48-pin TQFP package. The device is RoHS-compliant and targets BLDC motor drives for appliances, fans, and industrial automation equipment.

MCP2021A-330E/MD is a fully integrated LIN transceiver with a built-in 3.3 V LDO voltage regulator from Microchip, combining bus interface and local power supply in a compact 8-lead DFN package for automotive and industrial network nodes.

The MCP2021A-500E/SN is a LIN bus transceiver with integrated voltage regulator from Microchip Technology, supporting SAE J2602 at up to 20 kBd data rate. It provides a single-channel LIN physical layer interface and onboard 5 V regulator in an 8-pin SOIC package, ideal for automotive body electronics and slave node designs.

Microchip MCP2021A-500E/MD is a LIN 2.x compatible transceiver integrated with a 5.0 V LDO voltage regulator in an 8-pin DFN package, providing a single-chip solution for automotive LIN slave nodes that require bus communication and local power supply from a 12 V vehicle rail.

MCP79510-I/MS is a real-time clock/calendar IC with SPI interface, 64-byte SRAM, and EEPROM, supporting 1.8V to 5.5V supply and clock frequencies up to 32 kHz for time-keeping applications.

The MCP2221A-I/ML is a USB 2.0 full-speed to I2C/UART protocol converter IC from Microchip. Housed in a compact 16-pin QFN package, it provides USB-to-I2C, USB-to-UART, and GPIO bridging at up to 12 MHz, and is ideal for embedded debug interfaces and USB-to-serial adapters.

8-bit Microcontrollers - MCU AVR 32K FL 2K SRAM 1KB EE 20 MHZ GRN

Microchip MCP2021AT-500E/SN is a single-channel LIN bus transceiver operating at up to 20 kbps with a 12 V nominal bus voltage and integrated slope control. It is packaged in an 8-pin SOIC and targets automotive body electronics, HVAC, and low-speed node communication in LIN 2.x networks.

The PIC16F677-I/ML is an 8-bit CMOS microcontroller featuring 14 KB Flash memory, up to 20 MHz operation, and nanoWatt Technology for ultra-low power consumption. It integrates a 10-bit ADC, comparators, and USART communication in a compact 20-pin QFN package. Ideal for cost-sensitive embedded control applications requiring low power and analog capabilities.

Microchip PIC18F26K22-E/ML is an 8-bit PIC18 nanoWatt XLP microcontroller with 64 KB Flash and 3968 B RAM, running up to 64 MHz. It integrates an ADC, operates down to 2.3 V at 16 MHz, and comes in a VQFN-28 lead-free package.

The MCP2561-E/SN is a high-speed CAN (Controller Area Network) transceiver IC from Microchip, supporting data rates up to 1 Mbps, housed in an 8-pin SOIC package. It provides the physical layer interface between a CAN controller and the differential bus, with robust protection features for automotive and industrial reliability. Suitable for automotive ECUs, industrial networks, and embedded motor control systems.

Microchip MCP8026T-115H/PT is a 3-phase brushless DC motor gate driver with 0.5A gate drive output current in a 48-pin TQFP package. It integrates comprehensive protection and control features for sensorless or sensored BLDC motor applications. Available from stock worldwide with global shipping.

The Microchip MCP45HV51T-104E/ST is a single-channel, 8-bit volatile digital potentiometer with a 100 kΩ end-to-end resistance, controlled via a 2-wire I2C-compatible serial interface. Housed in a TSSOP-14 package, it supports high-voltage operation and targets industrial, audio, and calibration applications requiring software-adjustable resistance.

DIP-40

LEAD FREE, SOT-223, 4 PIN

Microchip MCP45HV51T-503E/ST is an 8-bit volatile digital potentiometer with a 50 kΩ resistance and 2-wire serial (I2C) control interface. It supports resistor array values of 5 kΩ, 10 kΩ, and 50 kΩ in a 14-pin TSSOP package, suitable for programmable gain and calibration applications.

MICREL SEMICONDUCTOR - MIC5014YN - MOSFET DRIVER, HIGH/LOW SIDE, DIP-8

PIC24FV32KA301-I/SO is a 16-bit PIC24F microcontroller with 32 KB Flash, 32 MHz max clock, and XLP ultra-low power technology in a 20-pin SOIC package. Ideal for battery-powered and IoT embedded designs.

Microchip PIC16F1614-I/ST is an 8-bit MCU in TSSOP-14 package, offering 7KB Flash, 512B RAM, 10-bit ADC, DAC channels, and 32 MHz max clock. From $0.80 in stock, worldwide shipping.

I2C-Compatible (2-wire) Serial EEPROM

Microchip MCP1754ST-3302E/CB is a fixed 3.3 V, 150 mA LDO linear regulator in 3-pin SOT-23A package with 0.5 V maximum dropout and 2% output accuracy. Suited for battery-powered and space-constrained embedded applications.

The 24LC08B/P is an 8 Kbit I2C serial EEPROM from Microchip, supporting 400 kHz clock, 16-byte page writes, 1 million write/erase cycles, and 200-year data retention on a 2.5V to 5.5V supply. Available in an 8-pin PDIP package for embedded configuration storage worldwide.

TO-263, 5 PIN

QFN-16

LQFP-100

PIC24FV32KA301-I/P is a 16-bit PIC24 microcontroller by Microchip with 32 KB Flash, 32 MHz clock, and an integrated ADC in a 20-pin PDIP package. Key specs: 2 V to 3.6 V supply range, 16 MIPS performance, and low-power sleep modes for battery applications. Available from stock worldwide.

8-bit Microcontrollers - MCU 16KB Flash 768b RAM SERIAL EE IND

0.300 INCH, GREEN, PLASTIC, MS-001BA, DIP-8

The MCP4018T-503E/LT is a single-channel 50 kΩ digital potentiometer from Microchip Technology with 128 wiper positions and a 2-wire I2C-compatible serial interface. It operates over a wide supply voltage range, is packaged in a 6-pin SOT-23 for minimal board space, and is RoHS-compliant.

MCP4542-103E/MS is a single 7-bit digital potentiometer from Microchip with non-volatile memory, 10 kΩ end-to-end resistance, I2C interface with increment/decrement control, and an 8-pin MSOP package for programmable gain, offset, and bias adjustment applications.

Microchip Technology MIC3775YMM, LDO Regulator, 750mA Adjustable, 1.24 → 6 V, ±2% 8-Pin, MSOP