Integrated Circuit

Power Management Specialized - PMIC RMS-DC CONVERTER IC

The LT6370HS8E#PBF is a low-drift, low-noise instrumentation amplifier from Analog Devices with 55 µV max offset voltage, 88 dB CMRR, and 3.1 MHz bandwidth in an 8-pin SOIC package. Available from stock with worldwide shipping.

Fractional-N PLL with Integrated VCO SMT, 1285 - 1415 MHz

The LT6005IGN#PBF is a quad precision micropower operational amplifier from Analog Devices operating from a 1.6 V supply with only 1 µA quiescent current per amplifier. It achieves 100 dB typical common-mode rejection ratio and a maximum input offset voltage of 1250 µV in a 16-pin SOIC package. Available from global distributors with worldwide shipping.

LT6370IMS8#PBF is a precision instrumentation amplifier from Analog Devices offering 35 µV max offset voltage, 88 dB min CMRR, and 3.1 MHz bandwidth. It delivers low-drift, low-noise differential signal amplification in an MSOP-8 package.

Digital Potentiometer ICs 1024tap 5v 50tp, 1% R-tol MSOP SPI I.C.

ADG1607BRUZ Analog Devices, Multiplexer Dual 8 x 2, 12 V, 28-Pin TSSOP

Digital Isolator CMOS 2-CH 10Mbps 8-Pin SOIC N Tube

Digital to Analog Converters - DAC Quad 12Bit DAC 0.5 LSB INL + 10ppm Ref

Digital to Analog Converters - DAC Quad 12Bit DAC 0.5 LSB INL + 10ppm Ref

Hot Swap Voltage Controllers Micropower Hot Swap Controller with Latchoff

Analog Devices LTC4400-1ES6 is an RF power controller IC featuring a 450 kHz control loop bandwidth and 45 dB dynamic range in a 6-pin SOT-23 package. It operates from a 3.6 V nominal supply and integrates an RF detector for closed-loop transmit power control in wireless systems. Available from authorized distributors with in-stock inventory and worldwide shipping.

Switching Voltage Regulators 4A, 2MHz Step-Down Regulator with Integrated Switches

CAN Interface IC 5.7kV Isolated CAN-FD Transceiver

Temperature Sensor Digital, Local 0°C ~ 70°C 16 b 10-LGA (2x2)

Single-Supply Integrated Optical Module for HR and SpO2 Measurement

Gate Drivers Dual-Power MOSFET Drivers

Analog Devices MAX3232CSE+T is a dual RS-232 line transceiver in a 16-pin SOIC package operating from a single 3.3 V supply with an internal charge pump. It provides 2 drivers and 2 receivers with Schmitt-trigger inputs for reliable serial communication. Available from stock in tape-and-reel with worldwide shipping.

Instrumentation Amplifiers IC 40uA MicroPower

Digital Potentiometer ICs 1024tap 5v 50tp, 1% R-tol MSOP SPI I.C.

Operational Amplifiers - Op Amps SOT23 SINGLE LOW POWER OP AMP 2.7 V, 800 μA, 80 MHz Rail-to-Rail I/O Amplifiers

Analog Devices LTC2909CTS8-2.5#TRMPBF is an automotive-grade dual-channel undervoltage/overvoltage supervisor with a 2.5 V internal reference, 3 active-low open-drain reset outputs, in an 8-pin TSOT-23 package. Monitors 2 supply rails with adjustable thresholds and <1% threshold accuracy. Available on tape and reel from stock worldwide with fast shipping.

Data Acquisition ADCs/DACs - Specialized DDS CLOCK DRIVER

Analog Devices LTC4231IMS-2 is a single-channel hot swap controller supporting 2.7 V to 36 V input range with N-channel MOSFET control in a 12-pin MSOP package for automotive and industrial hot-plug designs. From $5.80 in stock with worldwide shipping.

Analog Devices LTC4236CUFD-2#PBF is a single-channel hot swap controller supporting up to 18 V with adjustable current limiting, packaged in a compact 28-pin QFN with exposed pad for high-density designs. It enables safe board insertion and removal in live systems with integrated FET drive and fault protection. Available from stock worldwide with fast shipping.

The LTC4364CDE-2#TRPBF is a surge stopper with integrated ideal diode from Analog Devices, protecting loads against input voltage transients with a 2.2 V output reset threshold in a compact 14-lead 4 mm × 3 mm DFN package. Available from stock with worldwide shipping.

Linear Voltage Regulators 150mA LDO 3.3Vout w/ QOD

Analog Devices LT1374HVCR#PBF is a high-voltage, 4.5 A, 500 kHz current-mode PWM step-down switching regulator in a D2PAK-8 surface-mount package. It accepts input voltages from 5 V to 32 V and delivers regulated output with high efficiency. Available from stock with worldwide shipping.

Analog Devices LT1490AHMS8 is a dual general-purpose rail-to-rail input/output operational amplifier rated for ±22 V (44 V single-supply) operation in an automotive-grade 8-pin MSOP package. It features 72 dB CMRR and low 20 nA bias current, suitable for battery-powered and automotive sensor circuits.

Guaranteed ±4.5V to ±18V Operation ♦ No VL Supply Required ♦ Nonlatching with Supplies Turned Off and Input Signals Present ♦ CMOS and TTL Logic Compatible ♦ Monolithic, Low-Power CMOS Design

LT1039ISW#PBF is a triple RS-232 driver/receiver IC with 3 driver channels and Schmitt-trigger inputs, operating from a single supply in an 18-pin SOIC package. One receiver remains active during shutdown mode, preserving bus monitoring capability. Available from stock worldwide with competitive pricing.

Voltage References +5V PrecisionBandgap REF

Analog Devices LTC3864MPDE#TRPBF is a 60 V low quiescent current step-down DC/DC controller with 100% duty cycle capability in a 12-lead 4 mm × 3 mm DFN package. Supports 3.5 V to 60 V input range with current-mode PWM control. Available from stock with worldwide shipping.

Linear Voltage Regulators 500 mA adjustable anyCAP LDO

The MAX863EEE+ is a dual high-efficiency PFM step-up DC-DC controller from Analog Devices, accepting 1.5 V to 11 V input and driving two independent boost converters in a 16-pin QSOP package for battery-powered portable electronics.

LTC3859ALEUHF#PBF is an Analog Devices triple-output synchronous switching controller with two buck channels and one boost channel, accepting 4.5 V to 38 V input and supporting output voltage from 0.8 V to 24 V. It features a 28 µA Burst Mode quiescent current for high-efficiency light-load operation using current-mode PWM control. Available from authorized distributors with worldwide shipping.

Ethernet ICs Industrial Ethernet Gigabit PHY

Analog Devices LT1374CR#PBF is a single-channel current-mode PWM step-down DC-DC converter delivering up to 4.5 A output from a 5 V to 25 V input supply. It integrates the power switch in a 7-pin D2PAK package for efficient thermal management in high-current buck regulators. Available with worldwide shipping for industrial and consumer power designs.

Analog Devices LTC3605AIUF#TRPBF is a 4 V to 20 V input, 5 A synchronous step-down switching regulator supporting PolyPhase operation for reduced ripple in a 24-pin QFN package. Available in stock with worldwide shipping.

Variable Resolution, 10-Bit to 16-Bit R/D Converter with Reference Oscillator

Analog Devices LTC6700-3 is a micropower, low-voltage dual comparator with an integrated 400 mV reference, operating from 1.6 V to 5.5 V supply in a compact 6-pin SOT-23 package. Available in stock worldwide with fast shipping.

LT1492CS8#TRPBF is a dual single-supply operational amplifier with 5 MHz gain-bandwidth product and 3 V/µs slew rate in an 8-pin SOIC package. Features 84 dB minimum CMRR and 0.12 µA maximum bias current, optimized for precision signal conditioning. Available in stock with worldwide shipping.

The LTC3305IFE#PBF is a lead-acid battery balancer IC from Analog Devices designed to equalize charge across multi-cell battery stacks. It monitors up to 4 cells in series, actively balancing with an adjustable threshold. Available from stock with worldwide shipping.

16 BUMPS WLP PKG. 0.35 mm PITCH,W161K1+1 Tiny, Ultra-Low-Power Arm Cortex-M4 Processor with FPU-Based Microcontroller (MCU) with 256KB Flash and 96KB SRAM

The LT1492CN8 is a dual precision operational amplifier from Analog Devices offering 5 MHz bandwidth, 3 V/µs slew rate, and low-power single-supply operation down to 2.7 V. Input offset voltage is max 550 µV with 84 dB CMRR minimum. Available from stock worldwide with fast shipping.

Supervisory Circuits Nanopower A P Supervisory Circuits with Manual Reset and Watchdog Timer

Analog Devices LT1121ACS8#PBF is an adjustable micropower low-dropout regulator with shutdown in an 8-pin SOIC package. Features 0.42V typical dropout voltage and up to 19.3V input-output differential for wide supply range applications. RoHS-compliant lead-free version available worldwide with 9+ years estimated product lifetime.

Audio Amplifiers Low-Cost, Mono/Stereo, 1.4W Differential Audio Power Amplifiers

The LT1492CN8#PBF from Analog Devices is a dual general-purpose voltage-feedback op-amp operating on supplies up to ±18 V or 36 V single-supply with a 101 dB typical CMRR and 0.1 µA bias current in an 8-pin PDIP package. It delivers precision analog signal conditioning across industrial temperature ranges for instrumentation and audio applications. Available from authorized distributors with worldwide shipping.

LT3063EDCB#TRMPBF is a 45 V input, 200 mA low-dropout linear regulator with micropower quiescent current, low noise output, and active output discharge in an 8-lead SON package. Features 0.3 V typical dropout voltage and adjustable output for precision low-power supply rails. Available in stock with worldwide shipping.