Integrated Circuit

Analogue Switch ICs Quadruple Bilateral Analog Switches

0.66A, 2.7-5.5V Single Hot-Swap IC Hi-Side MOSFET, Fault Report, Act-High Enable

The CD4049UBNSRG4 is a CMOS hex inverting buffer and converter from Texas Instruments in the 4000-series logic family, providing six independent single-input inverting buffer stages with 50pF load capacity. It is housed in a 16-pin SOIC package and operates across a wide supply voltage range, making it suitable for logic level translation and signal inversion in mixed-voltage digital systems.

TEXAS INSTRUMENTS - TPS3779CDBVT - VOLTAGE DETECTOR, DUAL, 6.5V, SOT-23-6

IC D-TYPE POS TRG SNGL 16DIP

Analog to Digital Converters - ADC 20-bit,32 channel currrent inputs

Analog Switch ICs QUAD Bilateral Analog Switches

Counter/Divider Dual 4-Bit Binary UP 14-Pin CDIP Tube

Single Transmitter/Receiver RS-485 Automotive 8-Pin SOIC T/R

Analog Comparators Nanopower 1.8V Push-Pull

The CD4585BF3A is a 4-bit magnitude comparator from Texas Instruments in the 4000/14000/40000 CMOS logic family, supporting cascadable operation for wider word comparisons. It evaluates whether a 4-bit binary value is greater than, equal to, or less than another, with a 50pF load capacitance, housed in a 16-pin ceramic DIP package for high-reliability digital comparison applications.

Operational Amplifiers - Op Amps Lo Pwr Single-Sply Rail-to-Rail

The TVP5150AM1IPBSRQ1 is an automotive-grade color video decoder IC with a 9-bit ADC and component video (Y, R-Y, B-Y) input in a 32-pin TQFP package. It decodes analog color signals for in-vehicle display and camera systems with AEC-Q100 automotive qualification. Available from Texas Instruments with worldwide shipping.

Temp Sensor Digital Serial (2-Wire) 8-Pin VSSOP T/R

The TPS54286PWPRG4 is a 2A non-synchronous step-down (buck) DC/DC converter from Texas Instruments. It accepts a wide input voltage range of 4.5V to 28V and regulates output voltages from 0.8V to 25.2V using current-mode PWM control. Available in a TSSOP-14 (HTSSOP) package, it is designed for point-of-load power conversion in industrial, communications, and consumer electronics applications.

Schmitt Trigger Buffer 2-CH Non-Inverting Push-Pull CMOS 6-Pin SC-70 T/R

Operational Amplifiers - Op Amps 1MHz 45uA RRIO Single Op Amp

The SN74ACT240DWE4 is an octal buffer and line driver IC from Texas Instruments with inverting 3-state outputs, built using ACT CMOS technology. It offers 24 mA output low current drive capability, operates from a 4.5 V to 5.5 V supply, and is housed in a 20-pin SOIC package for high-drive bus interface applications.

The SN74HC125DRG4 is a quad bus buffer and line driver from Texas Instruments with 3-state outputs, featuring four independent non-inverting buffer channels each controlled by an active-low output enable pin. Operating from 2V to 6V supply using High-Speed CMOS (HC) technology, it provides 6 mA sink current in a 14-pin SOIC package on tape and reel. Ideal for bus isolation, signal driving, and data bus interfacing applications.

The CD54HC237F is a CMOS 3-to-8 line decoder and demultiplexer with integrated address latches and 3 enable inputs, housed in a 16-pin ceramic DIP package for high-reliability applications. It drives 50 pF loads and is available from distributors worldwide with fast shipping.

The TLC374CPWRG4 is a quad LinCMOS differential comparator IC from Texas Instruments with four independent comparator channels and open-drain outputs. It features a bias current of 0.6 nA maximum, 6.5 mV maximum input offset voltage, and operates over a standard temperature range, packaged in a 14-pin TSSOP for compact digital interface designs.

Use the download button to access the TMP112NAIDRLT schematic symbol, PCB footprint, and 3D model.

The CD4504BEG4 is a CMOS hex voltage level shifter from Texas Instruments designed for unidirectional voltage translation between different logic families. Housed in a 16-pin DIP package, it enables interfacing between CMOS and TTL logic levels, supporting both 3V-to-5V and 5V-to-12V translation. The device features a voltage select input pin allowing selection between two operating modes for bi-level translation applications.

Use the download button to access the TPS53681RSBR schematic symbol, PCB footprint, and 3D model.

The CD4063BF is a 4-bit magnitude comparator IC from Texas Instruments in a ceramic DIP-16 package. It supports cascading for wider bit comparisons and operates with a 50 pF load capacitance. Available in stock with worldwide shipping.

The SN65LBC176APG4 is a differential bus transceiver from Texas Instruments designed for RS-485 and RS-422 serial communication, supporting half-duplex operation over balanced differential lines. It integrates a driver and receiver in a single 8-pin DIP package, providing robust noise immunity and up to 32-unit load capacity for industrial multi-drop bus networking applications.

400 Mbps LVDS Quad High Speed Differential Driver

Operational Amplifiers - Op Amps Dual Wide-Bandwidth Hi-Output-Drv Op Amp

TEXAS INSTRUMENTS - SN65LVDS31PWRG4 - DIFFERENTIAL LINE DRIVER QUAD TSSOP16, FULL REEL

TSSOP-20

Buffers & Line Drivers Octal Buffer/Driver With 3-State Outputs

Buffer 3-CH Non-Inverting CMOS 8-Pin VSSOP T/R

DIP-16

Logic Gates Quadruple 2-Input Positive-AND Gate

Use the download button to access the LMZM23600V3SILT schematic symbol, PCB footprint, and 3D model.

The TPS3307-18DGNRG4 is a triple-channel automotive-grade processor supervisor and voltage reset IC from Texas Instruments, monitoring 2.93V and 1.68V rails with adjustable threshold and supporting manual reset input with power-on reset generation in a compact 8-pin HVSSOP package. Qualified for automotive applications with RoHS e4 compliance. Available from stock with worldwide shipping.

TEXAS INSTRUMENTS - SN74ACT86PW. - IC, QUAD 2 INPUT

IC DECODER/DEMUX DUAL 16TSSOP

Buffers & Line Drivers Octal Buffer/Driver With 3-State Outputs

Operational Amplifiers - Op Amps Dual Wide-Bandwidth Hi-Output-Drv Op Amp

Use the download button to access the CD4063BF3A schematic symbol, PCB footprint, and 3D model.

Operational Amplifiers - Op Amps Dual Wide-Bandwidth Hi-Output-Drv Op Amp

Use the download button to access the TLC072CDGN schematic symbol, PCB footprint, and 3D model.

Switching Controllers LOW-Pwr BICMOS CUR-MODE PWM

3.3-V ABT Octal Buffers/Drivers With 3-State Outputs

1:8 3.3-V Phase Lock Loop Clock Driver

DAC7734EBG4 is a 16-bit quad-channel voltage output DAC from Texas Instruments with ±10V output range, 0.0061% max linearity error, and serial binary input interface in a 48-pin SOIC package. It operates from a ±15V supply for high-accuracy analog control in instrumentation and process control systems. Available from stock worldwide with competitive pricing.

Differential Bus Transceivers

Single Transmitter/Receiver RS-485 8-Pin SOIC T/R

10MHz, CMOS, Zero-Drift, Zero-Crossover, True RRIO Precision Operational Amplifier