Analog Devices

16 Bit Digital to Analog Converter 4 16-TSSOP 2.7V ~ 5.5V,-40°C ~ 125°C

Micropower, OVP, RRIO, Quad Op Amp

Analog Devices AD5100YRQZ-1REEL is a factory-programmed 4-channel voltage monitoring and supervisory IC in a 16-pin SSOP package, providing simultaneous supervision of four supply rails with programmable thresholds and reset/fault outputs for system management in industrial and communications equipment. Available in stock with worldwide shipping.

16 Bit Digital to Analog Converter 4 16-TSSOP Fully Accurate, 16-Bit, Unbuffered VOUT, Quad SPI Interface, 2.7 V to 5.5 V nanoDAC in a TSSOP

2.5 V to 5.0 V Micropower, Precision Series Mode Voltage References

PWM Temperature Sensor

AMPLIFIER, CLASS G, 50mW, WLCSP-16

IC, OP-AMP, 900KHZ, 0.2V/ us, SOIC-8

Analog Devices OP293FS-REEL is a precision voltage-feedback operational amplifier with 35 kHz gain-bandwidth product, 0.015 V/µs slew rate, 100 dB minimum CMRR, and 0.02 µA maximum bias current in an 8-pin SOIC package on tape and reel. Available from stock with worldwide shipping.

Digital-to-Analog Converters

Micropower, RRIO Dual Op Amp

14-Output Clock Generator with Integrated 2.8 GHz VCO

Precision Operational Amplifiers

Precision Analog Microcontroller

Quad 8-Bit Multiplying CMOS D/A Converter with Memory PLCC-28

750 MHz, 16 x 8 Analog Crosspoint Switch

General Purpose Amplifier 2 Circuit Rail-to-Rail 8-SOIC

The ADUC848BS32-5 is an 8-bit microcontroller from Analog Devices integrating ADC, DAC channels, and a 24-bit address bus in a 52-pin MQFP package. It operates at a maximum clock frequency of 32 kHz and supports supply voltages down to 2.85 V for low-power applications. Designed for precision measurement instruments, data loggers, and embedded control systems requiring integrated analog conversion.

IC, DIGITAL ISOLATOR

Board Mount Temperature Sensors +/- 0.5 C, 12-Bit Dig Temp Sensor I.C.

ADUC847BSZ8-3 is a Analog Devices microcontroller for embedded control and motor control. It combines 52 pins, QFP, -40°C to 125°C for reliable board-level integration. Quote-based sourcing supports stock checks and worldwide shipping.

Digital Isolators iCoupler Digital Isolator

Video Crosspoint Switches

Voltage References SOT23-5 Voltage Reference

LQFP-208,SHARC Processor

Precision Analog Microcontroller

LFCSP-64,Precision Analog Microcontroller

IC, MIXER, 750-1160MHZ

DEMOD, QUAD, 750-1150M

LFCSP-40

IC, RF MIXER, 2.5GHz to 2.9GHz

Use the download button to access the ADRF6701ACPZ-R7 schematic symbol, PCB footprint, and 3D model.

12-Bit Serial Analog-to-Digital Converters

1.2 V Ultralow Power High PSRR Voltage Reference

Charger IC Lithium Ion 20-WLCSP (2.04x2.71)

Voltage References +5V PrecisionBandgap REF

Voltage References 2.5V PrecisionBandgap REF

2 Amp Synchronous, Step-Down DC-to-DC Converter

2 Amp Synchronous, Step-Down DC-to-DC Converter

1.5 Amp Synchronous, Step-Down DC-to-DC Converter

Ultralow noise preamplifier (preamp) Voltage noise = 0.74 nV/√Hz Current noise = 2.5 pA/√Hz 3 dB bandwidth AD8331: 120 MHz AD8332, AD8334: 100 MHz Low power AD8331: 125 mW/channel AD8332, AD8334: 145 mW/channel Wide gain range with programmable postamp −4.5 dB to +43.5 dB in LO gain mode 7.5 dB to 55.5 dB in HI gain mode Low output-referred noise: 48 nV/√Hz typical Active input impedance matching Optimized for 10-bit/12-bit ADCs Selectable output clamping level Single 5 V supply operation A

8-Bit, Complete, 32 MSPS A/D Converter

IC, DC-DC CONV, 1.725MHz

Power Factor Correction - PFC Digital Power Factor & Input Power Meter

5 V, 12-Bit nanoDAC®, Serial Interface in MSOP and LFCSP Packages

700 MHz to 1000 MHz, 1 W RF Driver Amplifier

IC, CAN TX/RX, ISOLATED, 5V

0.1 µF, +5V CMOS RS-232 200kBPS Transceiver with 4 Drivers, 5 Receivers

1.8 V Analog-to-Digital Converter

High-Speed, 2-Channel RS232/V.28 Interface Devices