ADL5355ACPZ-R7 Analog Devices Integrated Circuit (Quad Flat No-Lead) In Stock

What are the key features of ADL5355ACPZ-R7?

• Integrated LO buffer, IF amplifier, and RF balun in a single CP-20 QFN die, reducing external component count by over 10 passives versus discrete implementations at 700 MHz to 2500 MHz
• High LO-to-RF isolation at 50 Ohm characteristic impedance suppresses LO leakage into the RF port, improving receiver sensitivity in cellular and ISM-band front-end designs
• Handles up to 20 dBm CW input power at the RF port, enabling use with high-power local oscillators and driver amplifiers without external attenuators in base-station receive chains

What is ADL5355ACPZ-R7 used for?

The ADL5355 is designed for cellular base-station receiver front ends, point-to-point microwave radio links, and software-defined radio platforms operating between 700 MHz and 2500 MHz where combining LO buffering, IF amplification, and balun functions in a single compact QFN reduces board area and inter-stage mismatch loss. Its high isolation between LO and RF ports suits FDD handset designs and WLAN 802.11b/g/n receivers that require clean LO injection to maintain low error-vector magnitude. Test and measurement instruments such as spectrum analyzers and vector network analyzers also benefit from its 50 Ohm wideband performance across the 700 MHz to 2.5 GHz range.

Compliance & Regulatory

Where can I find the ADL5355ACPZ-R7 datasheet?

Official datasheet from Analog Devices

Related Guides