Integrated Circuit

Analog to Digital Converters - ADC 2.7V-5.5V 16 Bit 1 MSPS Serial ADC

74AHCT1G00DBVRE4 is a single 2-input NAND gate by Texas Instruments in the AHCT logic family, housed in a 5-pin SOT-23 package. Key specs: 2 inputs, 8 mA output sink current, 15 pF load capacitance, 4.5 V–5.5 V supply. Available from stock with worldwide shipping.

The LM4782TA is a three-channel audio power amplifier IC from Texas Instruments, delivering 25 W per channel with 20 kHz bandwidth in a 27-pin ZIP package. Key specs: 3 channels, 25 W nominal output power, plastic ZIP-27 through-hole package. Available in stock with worldwide shipping.

Interface - CODECs Very Lo-Pwr Stereo CODEC

Monostable Multivibrator Dual Retriggerable Mono Multivibrators

Bus Transceivers Trapezoidal Waveform InterfacE Bus Trans

TEXAS INSTRUMENTS - TS3A5017PWR . - Analogue Switch, 2 Channels, SP4T, 12 ohm, 2.3V to 3.6V, TSSOP, 16 Pins

Texas Instruments SN74LVC245ADW, 1 Bus Transceiver, Bus Transceiver, 8-Bit Non-Inverting LVTTL, 20-Pin SOIC

Switching Voltage Regulators Tiny Low Inp Vltg Boost Cnvrtr

TEXAS INSTRUMENTS - MAX3232CDB . - Transceiver RS232, 2 Drivers, 3V-5.5V supply, SSOP-16

Use the download button to access the TXS0102DCTT schematic symbol, PCB footprint, and 3D model.

Use the download button to access the SN74LVC2G32DCTR schematic symbol, PCB footprint, and 3D model.

LDO Regulator Pos 3.3V 0.15A 5-Pin SOT-23 T/R

Quad High Slew Rate JFET-Input Operational Amplifier

Battery Management OverVtg Prot for 2/3 Ser Cell LiIon Batt

Operational Amplifiers - Op Amps Quad Low Noise JFET

Use the download button to access the TL4242DRJR schematic symbol, PCB footprint, and 3D model.

TEXAS INSTRUMENTS - PCA9306DCUT . - Level Translator, Bidirectional, 1.5 ns, 1.2 V to 7 V, US8-8

TEXAS INSTRUMENTS - TLK106RHBT - Ethernet Controller, 100 Mbps, IEEE 802.3u, 3 V, 3.6 V, VQFN, 32 Pins

Operational Amplifiers - Op Amps Low distortion (-120 dB), low noise (4.5nV/rtHz), quad audio op amp 16-WQFN -40 to 85

Use the download button to access the TPIC6259DWR schematic symbol, PCB footprint, and 3D model.

Texas Instruments SN74LVC2G17DCKT, Dual, Schmitt Trigger Buffer, Non-Inverting, 1.65 → 5.5 V, 6-Pin SC-70

Single Channel Single ADC Pipelined 250Msps 14-bit Parallel/LVDS 48-Pin VQFN EP T/R

CD54HCT08F is a High-Speed CMOS Logic Quad 2-Input AND Gate in PDIP-14 package. Features 50 pF load capacitance, 4 logic functions, and HCT family compatibility with TTL input levels. Available from stock with worldwide shipping.

LDO Regulator Pos 1.9V3V 0.2A/0.2A 6-Pin WSON T/R

The TLV7111812DSET is a dual 200mA low-dropout (LDO) voltage regulator featuring low noise and high PSRR, with a fixed 1.2V output. It operates from a 2V to 5.5V input supply with only 150mV typical dropout voltage. Available in a compact SOT-23-6 package, ideal for space-constrained power management designs.

Logic Gates Sgl 2-Input Pos-NAND Gate

Use the download button to access the SN74AHC245MDWREP schematic symbol, PCB footprint, and 3D model.

SN74LV4052AN Texas Instruments, Demultiplexer Dual 4:1, 2 → 5.5 V, 16-Pin PDIP

Supervisory Circuits Single Power SVS

Fuel Gauge Lead-Acid/Li-Ion/Li-Pol/NiCd/NiMH 16-Pin SOIC T/R

The TLC7705IPWRG4 is a single-channel power supply voltage supervisor and reset IC from Texas Instruments in an 8-pin TSSOP package. It monitors supply voltage levels and generates a reset signal to prevent microcontroller operation under brownout conditions. From $0.65 in stock with worldwide shipping.

Texas Instruments CD4076BF3A is a CMOS 4-bit D-type register with hold mode and dual output enable in a 16-pin ceramic DIP. Supports clock frequencies up to 3 MHz with 50 pF load and wide supply voltage range. Available from stock with worldwide shipping.

Battery Management Multi-Chemistry SBS

LDO Voltage Regulators Dl-output 3.3V/1.2V 1A/2A

32-bit Microcontrollers - MCU Soprano

PMCS1101A1BQDR is a precision isolated current sensor IC from Texas Instruments with an internal voltage reference, delivering analog voltage output proportional to current. Features galvanic isolation and high-accuracy sensing up to ±100 A from a 3.3 V or 5 V supply. Available from stock worldwide with fast shipping.

Use the download button to access the TPS259631DDAT schematic symbol, PCB footprint, and 3D model.

MCU 32-bit Tiva C ARM Cortex M4F RISC 128KB Flash 1.2V/3.3V 100-Pin LQFP T/R

Supervisory Circuits Automotive high-input voltage supervisor with manual reset and programmable-reset time delay 5-SOT-23 -40 to 125

Hot Swap Voltage Controllers 2.7-19V 130MA-2A SURGE CLAMPING EFUSE

Buffer/Line Driver 8-CH Inverting 3-ST CMOS Automotive 20-Pin TSSOP T/R

Use the download button to access the DRV8804DWR schematic symbol, PCB footprint, and 3D model.

Operational Amplifiers - Op Amps Dual Hi-Sp JFET-Input Op Amp

PMCS1100A2QDR is a precision isolated current sensor with analog voltage output and external reference input, housed in an 8-pin SOP package measuring 4.9 mm x 3.9 mm. It provides galvanic isolation for accurate current measurement in motor drives, power converters, and industrial sensing applications.

Buffers & Line Drivers 16-Bit Buffer/Driver With 3-State Outputs

High Speed Operational Amplifiers Ultra-low power, 50MHz rail-to-rail out, negative rail in, voltage-feedback op amp 8-VSSOP -40 to 125

The PTMUX1574DYYR is a low-capacitance 4-channel 2:1 SPDT analog multiplexer with powered-off protection, controlled by 1.8 V logic. It features a maximum on-state resistance of 4.5 Ω, 75 dB off-state isolation, and 0.07 Ω resistance matching across channels. Designed for portable and wearable applications, it protects downstream circuits when supply power is removed.

MCU 16-bit MSP430 MSP430 RISC 92KB Flash 2.5V/3.3V 113-Pin BGA MICROSTAR JUNIOR

SN74ALS32DRE4 is a quad 2-input positive-OR gate from Texas Instruments in the ALS logic family, operating at 5 V with 50 pF load capacitance and 8 mA output sink current. It is packaged in a 14-pin SOIC and is suited for high-speed TTL-compatible digital logic designs.